blob: c0e990b473ef920334e6e20442497604e6f69188 [file] [log] [blame]
/* SPDX-License-Identifier: GPL-2.0-only */
#ifndef _SOC_CHIP_H_
#define _SOC_CHIP_H_
#include <gpio.h>
#include <intelblocks/cfg.h>
#include <soc/acpi.h>
#include <soc/irq.h>
#include <stdint.h>
#define MAX_PCH_PCIE_PORT 20
/**
UPD_PCH_PCIE_PORT:
ForceEnable - Enable/Disable PCH PCIe port
PortLinkSpeed - Port Link Speed. Use PCIE_LINK_SPEED to set
**/
struct pch_pcie_port {
uint8_t ForceEnable;
uint8_t PortLinkSpeed;
};
struct soc_intel_xeon_sp_spr_config {
/* Common struct containing soc config data required by common code */
struct soc_intel_common_config common_soc_config;
/* Struct for configuring PCH PCIe port */
struct pch_pcie_port pch_pci_port[MAX_PCH_PCIE_PORT];
/**
* Interrupt Routing configuration
* If bit7 is 1, the interrupt is disabled.
*/
uint8_t pirqa_routing;
uint8_t pirqb_routing;
uint8_t pirqc_routing;
uint8_t pirqd_routing;
uint8_t pirqe_routing;
uint8_t pirqf_routing;
uint8_t pirqg_routing;
uint8_t pirqh_routing;
/**
* Device Interrupt Routing configuration
* Interrupt Pin x Route.
* 0h = PIRQA#
* 1h = PIRQB#
* 2h = PIRQC#
* 3h = PIRQD#
* 4h = PIRQE#
* 5h = PIRQF#
* 6h = PIRQG#
* 7h = PIRQH#
*/
uint16_t ir00_routing;
uint16_t ir01_routing;
uint16_t ir02_routing;
uint16_t ir03_routing;
uint16_t ir04_routing;
/**
* Device Interrupt Polarity Control
* ipc0 - IRQ-00-31 - 1: Active low to IOAPIC, 0: Active high to IOAPIC
* ipc1 - IRQ-32-63 - 1: Active low to IOAPIC, 0: Active high to IOAPIC
* ipc2 - IRQ-64-95 - 1: Active low to IOAPIC, 0: Active high to IOAPIC
* ipc3 - IRQ-96-119 - 1: Active low to IOAPIC, 0: Active high to IOAPIC
*/
uint32_t ipc0;
uint32_t ipc1;
uint32_t ipc2;
uint32_t ipc3;
uint64_t turbo_ratio_limit;
uint64_t turbo_ratio_limit_cores;
uint32_t pstate_req_ratio;
uint8_t vtd_support;
uint8_t x2apic;
/* Generic IO decode ranges */
uint32_t gen1_dec;
uint32_t gen2_dec;
uint32_t gen3_dec;
uint32_t gen4_dec;
/* TCC activation offset */
uint32_t tcc_offset;
enum acpi_cstate_mode cstate_states;
};
typedef struct soc_intel_xeon_sp_spr_config config_t;
#endif