| chip northbridge/intel/sandybridge |
| # IGD Displays |
| register "gfx.ndid" = "3" |
| register "gfx.did" = "{ 0x80000100, 0x80000240, 0x80000410, 0x80000410, 0x00000005 }" |
| |
| # Enable DisplayPort Hotplug with 6ms pulse |
| register "gpu_dp_d_hotplug" = "0x06" |
| |
| # Enable Panel as LVDS and configure power delays |
| register "gpu_panel_port_select" = "0" # LVDS |
| register "gpu_panel_power_cycle_delay" = "5" # T4: 400ms |
| register "gpu_panel_power_up_delay" = "400" # T1+T2: 40ms |
| register "gpu_panel_power_down_delay" = "150" # T3: 15ms |
| register "gpu_panel_power_backlight_on_delay" = "2100" # T5: 210ms |
| register "gpu_panel_power_backlight_off_delay" = "2100" # TD: 210ms |
| |
| # Set backlight PWM values |
| register "gpu_cpu_backlight" = "0x000001e8" |
| register "gpu_pch_backlight" = "0x03d00000" |
| |
| register "max_mem_clock_mhz" = "666" |
| |
| device cpu_cluster 0 on |
| chip cpu/intel/socket_rPGA989 |
| device lapic 0 on end |
| end |
| chip cpu/intel/model_206ax |
| # Magic APIC ID to locate this chip |
| device lapic 0xACAC off end |
| |
| register "c1_acpower" = "1" # ACPI(C1) = MWAIT(C1) |
| register "c2_acpower" = "3" # ACPI(C2) = MWAIT(C3) |
| register "c3_acpower" = "5" # ACPI(C3) = MWAIT(C7) |
| |
| register "c1_battery" = "1" # ACPI(C1) = MWAIT(C1) |
| register "c2_battery" = "3" # ACPI(C2) = MWAIT(C3) |
| register "c3_battery" = "5" # ACPI(C3) = MWAIT(C7) |
| end |
| end |
| |
| register "pci_mmio_size" = "1024" |
| |
| device domain 0 on |
| ioapic_irq 4 INTA 0x10 |
| ioapic_irq 4 INTB 0x11 |
| ioapic_irq 4 INTC 0x12 |
| ioapic_irq 4 INTD 0x13 |
| subsystemid 0x1ae0 0xc000 inherit |
| device pci 00.0 on end # host bridge |
| device pci 02.0 on end # vga controller |
| |
| chip southbridge/intel/bd82x6x # Intel Series 6 Cougar Point PCH |
| # GPI routing |
| # 0 No effect (default) |
| # 1 SMI# (if corresponding ALT_GPI_SMI_EN bit is also set) |
| # 2 SCI (if corresponding GPIO_EN bit is also set) |
| register "alt_gp_smi_en" = "0x0002" |
| register "gpi1_routing" = "1" |
| register "gpi7_routing" = "2" |
| |
| register "sata_port_map" = "0x1" |
| |
| # EC range is 0xa00-0xa3f |
| register "gen1_dec" = "0x003c0a01" |
| register "gen2_dec" = "0x003c0b01" |
| |
| register "c2_latency" = "1" |
| register "p_cnt_throttling_supported" = "0" |
| |
| device pci 16.0 on end # Management Engine Interface 1 |
| device pci 16.1 off end # Management Engine Interface 2 |
| device pci 16.2 off end # Management Engine IDE-R |
| device pci 16.3 off end # Management Engine KT |
| device pci 19.0 off end # Intel Gigabit Ethernet |
| device pci 1a.0 on # USB2 EHCI #2 |
| ioapic_irq 4 INTA 0x11 |
| end |
| device pci 1b.0 on # High Definition Audio |
| ioapic_irq 4 INTA 0x16 |
| end |
| device pci 1c.0 on end # PCIe Port #1 (WLAN) |
| device pci 1c.1 off end # PCIe Port #2 |
| device pci 1c.2 off end # PCIe Port #3 |
| device pci 1c.3 on # PCIe Port #4 (LAN) |
| # ioapic_irq 4 INTA 0x13 |
| end |
| device pci 1c.4 off end # PCIe Port #5 |
| device pci 1c.5 off end # PCIe Port #6 |
| device pci 1c.6 off end # PCIe Port #7 |
| device pci 1c.7 off end # PCIe Port #8 |
| device pci 1d.0 on # USB2 EHCI #1 |
| ioapic_irq 4 INTA 0x13 |
| end |
| device pci 1e.0 off end # PCI bridge |
| device pci 1f.0 on # LPC bridge |
| ioapic_irq 4 INTA 0x10 |
| chip superio/smsc/mec1308 |
| device pnp 2e.1 on # PM1 |
| io 0x60 = 0xb00 |
| end |
| device pnp 2e.2 off end # EC1 |
| device pnp 2e.3 off end # EC2 |
| device pnp 2e.4 off end # UART |
| device pnp 2e.7 on # KBC |
| irq 0x70 = 1 |
| end |
| device pnp 2e.8 on # EC0 |
| io 0x60 = 0x62 |
| end |
| device pnp 2e.9 on # MBX |
| io 0x60 = 0xa00 |
| end |
| end |
| chip ec/smsc/mec1308 |
| register "mailbox_port" = "0xa00" |
| device pnp ff.1 off end |
| end |
| |
| chip drivers/generic/ioapic |
| register "have_isa_interrupts" = "1" |
| register "irq_on_fsb" = "1" |
| register "enable_virtual_wire" = "1" |
| register "base" = "(void *)0xfec00000" |
| device ioapic 4 on end |
| end |
| chip drivers/pc80/tpm |
| device pnp 0c31.0 on end |
| end |
| end |
| device pci 1f.2 on # SATA Controller 1 |
| ioapic_irq 4 INTA 0x10 |
| end |
| device pci 1f.3 on # SMBus |
| ioapic_irq 4 INTC 0x17 |
| end |
| device pci 1f.5 off end # SATA Controller 2 |
| device pci 1f.6 on end # Thermal |
| end |
| end |
| end |