| chip soc/intel/alderlake |
| # Graphics |
| # TODO: |
| # register "panel_cfg" = "{ |
| # .up_delay_ms = 200, // T3 |
| # .backlight_on_delay_ms = 0, // T7 |
| # .backlight_off_delay_ms = 50, // T9 |
| # .down_delay_ms = 0, // T10 |
| # .cycle_delay_ms = 500, // T12 |
| # .backlight_pwm_hz = 200, // PWM |
| # }" |
| |
| # FSP Memory |
| register "enable_c6dram" = "1" |
| register "sagv" = "SaGv_Enabled" |
| |
| # FSP Silicon |
| register "eist_enable" = "1" |
| |
| register "cnvi_bt_core" = "1" |
| register "cnvi_bt_audio_offload" = "1" |
| |
| # Serial I/O |
| register "serial_io_i2c_mode" = "{ |
| [PchSerialIoIndexI2C0] = PchSerialIoPci, |
| }" |
| |
| register "serial_io_uart_mode" = "{ |
| [PchSerialIoIndexUART0] = PchSerialIoSkipInit, |
| }" |
| |
| # Power |
| register "pch_slp_s3_min_assertion_width" = "2" # 50ms |
| register "pch_slp_s4_min_assertion_width" = "3" # 1s |
| register "pch_slp_sus_min_assertion_width" = "3" # 500ms |
| register "pch_slp_a_min_assertion_width" = "3" # 2s |
| |
| # PM Util |
| register "pmc_gpe0_dw0" = "GPP_B" |
| register "pmc_gpe0_dw1" = "GPP_C" |
| register "pmc_gpe0_dw2" = "GPP_E" |
| |
| # Device Tree |
| device cpu_cluster 0 on end |
| |
| device domain 0 on |
| device ref igpu on |
| register "ddi_portA_config" = "1" |
| register "ddi_ports_config" = "{ |
| [DDI_PORT_A] = DDI_ENABLE_HPD, |
| [DDI_PORT_B] = DDI_ENABLE_HPD | DDI_ENABLE_DDC, |
| }" |
| end |
| device ref gna on end |
| device ref xhci on |
| # Motherboard USB Type C |
| register "usb2_ports[0]" = "USB2_PORT_MID(OC5)" |
| register "usb3_ports[2]" = "USB3_PORT_DEFAULT(OC3)" |
| |
| # Motherboard USB 3.0 |
| register "usb2_ports[2]" = "USB2_PORT_MID(OC_SKIP)" |
| register "usb3_ports[0]" = "USB3_PORT_DEFAULT(OC5)" |
| |
| # Daughterboard USB 3.0 |
| register "usb2_ports[6]" = "USB2_PORT_MID(OC0)" |
| register "usb3_ports[1]" = "USB3_PORT_DEFAULT(OC_SKIP)" |
| |
| # Internal Webcam |
| register "usb2_ports[CONFIG_CCD_PORT]" = "USB2_PORT_MID(OC_SKIP)" |
| |
| # Fingerprint Reader |
| register "usb2_ports[5]" = "USB2_PORT_MID(OC0)" |
| |
| # Daughterboard SD Card |
| register "usb2_ports[3]" = "USB2_PORT_MID(OC_SKIP)" |
| |
| # Internal Bluetooth |
| register "usb2_ports[9]" = "USB2_PORT_MID(OC_SKIP)" |
| end |
| device ref i2c0 on |
| chip drivers/i2c/hid |
| register "generic.hid" = ""STAR0001"" |
| register "generic.desc" = ""Touchpad"" |
| register "generic.irq" = "ACPI_IRQ_LEVEL_LOW(GPP_E12_IRQ)" |
| register "hid_desc_reg_offset" = "0x20" |
| device i2c 2c on end |
| end |
| end |
| device ref shared_sram on end |
| device ref cnvi_wifi on |
| chip drivers/wifi/generic |
| register "wake" = "GPE0_PME_B0" |
| device generic 0 on end |
| end |
| end |
| device ref heci1 on end |
| device ref sata on |
| register "sata_salp_support" = "1" |
| register "sata_ports_enable[1]" = "1" |
| register "sata_ports_dev_slp[1]" = "1" |
| end |
| device ref pcie_rp5 on # WiFi |
| chip drivers/wifi/generic |
| register "wake" = "GPE0_PME_B0" |
| device generic 0 on end |
| end |
| register "pch_pcie_rp[PCH_RP(5)]" = "{ |
| .clk_src = 2, |
| .clk_req = 2, |
| .flags = PCIE_RP_LTR | PCIE_RP_AER, |
| }" |
| smbios_slot_desc "SlotTypePciExpressGen3X1" |
| "SlotLengthShort" |
| "M.2/M 2230" |
| "SlotDataBusWidth1X" |
| chip soc/intel/common/block/pcie/rtd3 |
| register "enable_gpio" = "ACPI_GPIO_OUTPUT_ACTIVE_HIGH(GPP_D13)" |
| register "reset_gpio" = "ACPI_GPIO_OUTPUT_ACTIVE_LOW(GPP_H2)" |
| register "srcclk_pin" = "2" |
| device generic 0 on end |
| end |
| end |
| device ref pcie_rp9 on # SSD x4 |
| register "pch_pcie_rp[PCH_RP(9)]" = "{ |
| .clk_src = 1, |
| .clk_req = 1, |
| .flags = PCIE_RP_LTR | PCIE_RP_AER, |
| |
| }" |
| smbios_slot_desc "SlotTypeM2Socket3" |
| "SlotLengthLong" |
| "M.2/M 2280" |
| "SlotDataBusWidth4X" |
| chip soc/intel/common/block/pcie/rtd3 |
| register "enable_gpio" = "ACPI_GPIO_OUTPUT_ACTIVE_HIGH(GPP_D16)" |
| register "reset_gpio" = "ACPI_GPIO_OUTPUT_ACTIVE_LOW(GPP_H0)" |
| register "srcclk_pin" = "1" |
| device generic 0 on end |
| end |
| end |
| device ref uart0 on end |
| device ref pch_espi on |
| register "gen1_dec" = "0x00fc0201" |
| register "gen2_dec" = "0x00000381" |
| register "gen3_dec" = "0x00000511" |
| |
| chip drivers/pc80/tpm |
| device pnp 0c31.0 on end |
| end |
| |
| chip ec/starlabs/merlin |
| # Port pair 4Eh/4Fh |
| device pnp 4e.00 on end # IO Interface |
| device pnp 4e.01 off end # Com 1 |
| device pnp 4e.02 off end # Com 2 |
| device pnp 4e.04 off end # System Wake-Up |
| device pnp 4e.05 off end # PS/2 Mouse |
| device pnp 4e.06 on # PS/2 Keyboard |
| io 0x60 = 0x0060 |
| io 0x62 = 0x0064 |
| irq 0x70 = 1 |
| end |
| device pnp 4e.0a off end # Consumer IR |
| device pnp 4e.0f off end # Shared Memory/Flash Interface |
| device pnp 4e.10 off end # RTC-like Timer |
| device pnp 4e.11 off end # Power Management Channel 1 |
| device pnp 4e.12 off end # Power Management Channel 2 |
| device pnp 4e.13 off end # Serial Peripheral Interface |
| device pnp 4e.14 off end # Platform EC Interface |
| device pnp 4e.17 off end # Power Management Channel 3 |
| device pnp 4e.18 off end # Power Management Channel 4 |
| device pnp 4e.19 off end # Power Management Channel 5 |
| end |
| end |
| device ref hda on |
| register "pch_hda_audio_link_hda_enable" = "1" |
| register "pch_hda_idisp_codec_enable" = "1" |
| register "pch_hda_idisp_link_frequency" = "HDA_LINKFREQ_96MHZ" |
| register "pch_hda_idisp_link_tmode" = "HDA_TMODE_8T" |
| end |
| device ref smbus on end |
| end |
| end |