| # SPDX-License-Identifier: GPL-2.0-only |
| |
| # TODO: Update for birman |
| |
| chip soc/amd/phoenix |
| register "common_config.espi_config" = "{ |
| .std_io_decode_bitmap = ESPI_DECODE_IO_0x80_EN | ESPI_DECODE_IO_0X2E_0X2F_EN | ESPI_DECODE_IO_0X60_0X64_EN, |
| .generic_io_range[0] = { |
| .base = 0x3f8, |
| .size = 8, |
| }, |
| .generic_io_range[1] = { |
| .base = 0x600, |
| .size = 256, |
| }, |
| .io_mode = ESPI_IO_MODE_QUAD, |
| .op_freq_mhz = ESPI_OP_FREQ_16_MHZ, |
| .crc_check_enable = 1, |
| .alert_pin = ESPI_ALERT_PIN_PUSH_PULL, |
| .periph_ch_en = 1, |
| .vw_ch_en = 1, |
| .oob_ch_en = 1, |
| .flash_ch_en = 0, |
| }" |
| |
| register "i2c_scl_reset" = "GPIO_I2C0_SCL | GPIO_I2C1_SCL | |
| GPIO_I2C2_SCL | GPIO_I2C3_SCL" |
| |
| register "i2c[0].early_init" = "1" |
| register "i2c[1].early_init" = "1" |
| register "i2c[2].early_init" = "1" |
| register "i2c[3].early_init" = "1" |
| |
| # I2C Pad Control RX Select Configuration |
| register "i2c_pad[0].rx_level" = "I2C_PAD_RX_1_8V" |
| register "i2c_pad[1].rx_level" = "I2C_PAD_RX_1_8V" |
| register "i2c_pad[2].rx_level" = "I2C_PAD_RX_1_8V" |
| register "i2c_pad[3].rx_level" = "I2C_PAD_RX_1_8V" |
| |
| register "s0ix_enable" = "true" |
| |
| register "pspp_policy" = "DXIO_PSPP_DISABLED" # TODO: reenable when PSPP works |
| |
| register "usb_phy_custom" = "1" |
| register "usb_phy" = "{ |
| .Usb2PhyPort[0] = { |
| .compdistune = 0x3, |
| .pllbtune = 0x1, |
| .pllitune = 0x0, |
| .pllptune = 0xe, |
| .sqrxtune = 0x3, |
| .txfslstune = 0x3, |
| .txpreempamptune = 0x2, |
| .txpreemppulsetune = 0x0, |
| .txrisetune = 0x1, |
| .txvreftune = 0x3, |
| .txhsxvtune = 0x3, |
| .txrestune = 0x2, |
| }, |
| .Usb2PhyPort[1] = { |
| .compdistune = 0x3, |
| .pllbtune = 0x1, |
| .pllitune = 0x0, |
| .pllptune = 0xe, |
| .sqrxtune = 0x3, |
| .txfslstune = 0x3, |
| .txpreempamptune = 0x2, |
| .txpreemppulsetune = 0x0, |
| .txrisetune = 0x1, |
| .txvreftune = 0x3, |
| .txhsxvtune = 0x3, |
| .txrestune = 0x2, |
| }, |
| .Usb2PhyPort[2] = { |
| .compdistune = 0x3, |
| .pllbtune = 0x1, |
| .pllitune = 0x0, |
| .pllptune = 0xe, |
| .sqrxtune = 0x3, |
| .txfslstune = 0x3, |
| .txpreempamptune = 0x2, |
| .txpreemppulsetune = 0x0, |
| .txrisetune = 0x1, |
| .txvreftune = 0x3, |
| .txhsxvtune = 0x3, |
| .txrestune = 0x2, |
| }, |
| .Usb2PhyPort[3] = { |
| .compdistune = 0x3, |
| .pllbtune = 0x1, |
| .pllitune = 0x0, |
| .pllptune = 0xe, |
| .sqrxtune = 0x3, |
| .txfslstune = 0x3, |
| .txpreempamptune = 0x2, |
| .txpreemppulsetune = 0x0, |
| .txrisetune = 0x1, |
| .txvreftune = 0x3, |
| .txhsxvtune = 0x3, |
| .txrestune = 0x2, |
| }, |
| .Usb2PhyPort[4] = { |
| .compdistune = 0x3, |
| .pllbtune = 0x1, |
| .pllitune = 0x0, |
| .pllptune = 0xe, |
| .sqrxtune = 0x3, |
| .txfslstune = 0x3, |
| .txpreempamptune = 0x2, |
| .txpreemppulsetune = 0x0, |
| .txrisetune = 0x1, |
| .txvreftune = 0x3, |
| .txhsxvtune = 0x3, |
| .txrestune = 0x2, |
| }, |
| .Usb2PhyPort[5] = { |
| .compdistune = 0x3, |
| .pllbtune = 0x1, |
| .pllitune = 0x0, |
| .pllptune = 0xe, |
| .sqrxtune = 0x3, |
| .txfslstune = 0x3, |
| .txpreempamptune = 0x2, |
| .txpreemppulsetune = 0x0, |
| .txrisetune = 0x1, |
| .txvreftune = 0x3, |
| .txhsxvtune = 0x3, |
| .txrestune = 0x2, |
| }, |
| .Usb2PhyPort[6] = { |
| .compdistune = 0x3, |
| .pllbtune = 0x1, |
| .pllitune = 0x0, |
| .pllptune = 0xe, |
| .sqrxtune = 0x3, |
| .txfslstune = 0x3, |
| .txpreempamptune = 0x2, |
| .txpreemppulsetune = 0x0, |
| .txrisetune = 0x1, |
| .txvreftune = 0x3, |
| .txhsxvtune = 0x3, |
| .txrestune = 0x2, |
| }, |
| .Usb2PhyPort[7] = { |
| .compdistune = 0x3, |
| .pllbtune = 0x1, |
| .pllitune = 0x0, |
| .pllptune = 0xe, |
| .sqrxtune = 0x3, |
| .txfslstune = 0x3, |
| .txpreempamptune = 0x2, |
| .txpreemppulsetune = 0x0, |
| .txrisetune = 0x1, |
| .txvreftune = 0x3, |
| .txhsxvtune = 0x3, |
| .txrestune = 0x2, |
| }, |
| .Usb3PhyPort[0] = { |
| .tx_term_ctrl = 0x2, |
| .rx_term_ctrl = 0x2, |
| .tx_vboost_lvl_en = 0x0, |
| .tx_vboost_lvl = 0x5, |
| }, |
| .Usb3PhyPort[1] = { |
| .tx_term_ctrl = 0x2, |
| .rx_term_ctrl = 0x2, |
| .tx_vboost_lvl_en = 0x0, |
| .tx_vboost_lvl = 0x5, |
| }, |
| .Usb3PhyPort[2] = { |
| .tx_term_ctrl = 0x2, |
| .rx_term_ctrl = 0x2, |
| .tx_vboost_lvl_en = 0x0, |
| .tx_vboost_lvl = 0x5, |
| }, |
| .ComboPhyStaticConfig[0] = USB_COMBO_PHY_MODE_USB_C, |
| .ComboPhyStaticConfig[1] = USB_COMBO_PHY_MODE_USB_C, |
| .ComboPhyStaticConfig[2] = USB_COMBO_PHY_MODE_USB_C, |
| .BatteryChargerEnable = 0, |
| .PhyP3CpmP4Support = 0, |
| }" |
| |
| register "gpp_clk_config[0]" = "GPP_CLK_REQ" # MXM |
| register "gpp_clk_config[1]" = "GPP_CLK_REQ" # NVMe SSD1 |
| register "gpp_clk_config[2]" = "GPP_CLK_REQ" # NVMe SSD0 |
| register "gpp_clk_config[3]" = "GPP_CLK_REQ" # WLAN |
| register "gpp_clk_config[4]" = "GPP_CLK_REQ" # WWAN |
| register "gpp_clk_config[5]" = "GPP_CLK_REQ" # SD |
| register "gpp_clk_config[6]" = "GPP_CLK_REQ" # GBE |
| |
| device domain 0 on |
| device ref iommu on end |
| device ref gpp_bridge_1_1 on end # MXM |
| device ref gpp_bridge_1_2 on |
| # Required so the NVMe gets placed into D3 when entering S0i3. |
| chip drivers/pcie/rtd3/device |
| register "name" = ""NVME"" |
| device pci 00.0 on end |
| end |
| end # NVMe SSD1 |
| device ref gpp_bridge_1_3 on end # GBE |
| device ref gpp_bridge_2_1 on end # SD |
| device ref gpp_bridge_2_2 on end # WWAN |
| device ref gpp_bridge_2_3 on end # WIFI |
| device ref gpp_bridge_2_4 on |
| # Required so the NVMe gets placed into D3 when entering S0i3. |
| chip drivers/pcie/rtd3/device |
| register "name" = ""NVME"" |
| device pci 00.0 on end |
| end |
| end # NVMe SSD0 |
| device ref gpp_bridge_a on # Internal GPP Bridge 0 to Bus A |
| device ref gfx on end # Internal GPU (GFX) |
| device ref gfx_hda on end # Display HD Audio Controller (GFXAZ) |
| device ref crypto on end # Crypto Coprocessor |
| device ref xhci_0 on # USB 3.1 (USB0) |
| chip drivers/usb/acpi |
| device ref xhci_0_root_hub on |
| chip drivers/usb/acpi |
| device ref usb3_port0 on end |
| end |
| chip drivers/usb/acpi |
| device ref usb3_port1 on end |
| end |
| chip drivers/usb/acpi |
| device ref usb2_port0 on end |
| end |
| chip drivers/usb/acpi |
| device ref usb2_port1 on end |
| end |
| chip drivers/usb/acpi |
| device ref usb2_port2 on end |
| end |
| chip drivers/usb/acpi |
| device ref usb2_port3 on end |
| end |
| chip drivers/usb/acpi |
| device ref usb2_port4 on end |
| end |
| end |
| end |
| end |
| device ref xhci_1 on # USB 3.1 (USB1) |
| chip drivers/usb/acpi |
| device ref xhci_1_root_hub on |
| chip drivers/usb/acpi |
| device ref usb3_port5 on end |
| end |
| chip drivers/usb/acpi |
| device ref usb2_port5 on end |
| end |
| end |
| end |
| end |
| device ref acp on end # Audio Processor (ACP) |
| end |
| device ref gpp_bridge_c on # Internal GPP Bridge 2 to Bus C |
| end |
| end |
| |
| device ref i2c_0 on end |
| device ref i2c_1 on end |
| device ref i2c_2 on end |
| device ref i2c_3 on end |
| device ref uart_0 on end # UART0 |
| |
| end |