| #ifndef __CONFIG_H |
| #define __CONFIG_H |
| |
| #include "autoconf.h" |
| |
| // Configuration definitions. |
| |
| //#define BUILD_APPNAME "QEMU" |
| //#define BUILD_CPUNAME8 "QEMUCPU " |
| //#define BUILD_APPNAME6 "QEMU " |
| //#define BUILD_APPNAME4 "QEMU" |
| #define BUILD_APPNAME "Bochs" |
| #define BUILD_CPUNAME8 "BOCHSCPU" |
| #define BUILD_APPNAME6 "BOCHS " |
| #define BUILD_APPNAME4 "BXPC" |
| |
| // Maximum number of map entries in the e820 map |
| #define BUILD_MAX_E820 32 |
| // Space to reserve in high-memory for tables |
| #define BUILD_MAX_HIGHTABLE (256*1024) |
| // Largest supported externaly facing drive id |
| #define BUILD_MAX_EXTDRIVE 16 |
| // Number of bytes the smbios may be and still live in the f-segment |
| #define BUILD_MAX_SMBIOS_FSEG 600 |
| // Maximum number of bytes the mptable may be and still be copied to f-segment |
| #define BUILD_MAX_MPTABLE_FSEG 600 |
| |
| #define BUILD_MODEL_ID 0xFC |
| #define BUILD_SUBMODEL_ID 0x00 |
| #define BUILD_BIOS_REVISION 0x01 |
| |
| // Various memory addresses used by the code. |
| #define BUILD_STACK_ADDR 0x7000 |
| #define BUILD_S3RESUME_STACK_ADDR 0x1000 |
| #define BUILD_AP_BOOT_ADDR 0x10000 |
| #define BUILD_EBDA_MINIMUM 0x90000 |
| #define BUILD_LOWRAM_END 0xa0000 |
| #define BUILD_ROM_START 0xc0000 |
| #define BUILD_BIOS_ADDR 0xf0000 |
| #define BUILD_BIOS_SIZE 0x10000 |
| #define BUILD_EXTRA_STACK_SIZE 0x800 |
| #define BUILD_SMM_INIT_ADDR 0x30000 |
| #define BUILD_SMM_ADDR 0xa0000 |
| |
| #define BUILD_PCIMEM_START 0xe0000000 |
| #define BUILD_PCIMEM_END 0xfec00000 /* IOAPIC is mapped at */ |
| #define BUILD_PCIMEM64_START 0x8000000000ULL |
| #define BUILD_PCIMEM64_END 0x10000000000ULL |
| |
| #define BUILD_IOAPIC_ADDR 0xfec00000 |
| #define BUILD_IOAPIC_ID 0 |
| #define BUILD_HPET_ADDRESS 0xfed00000 |
| #define BUILD_APIC_ADDR 0xfee00000 |
| |
| // PCI IRQS |
| #define BUILD_PCI_IRQS ((1<<5) | (1<<9) | (1<<10) | (1<<11)) |
| |
| // Important real-mode segments |
| #define SEG_IVT 0x0000 |
| #define SEG_BDA 0x0040 |
| #define SEG_BIOS 0xf000 |
| |
| // Segment definitions in protected mode (see rombios32_gdt in misc.c) |
| #define SEG32_MODE32_CS (1 << 3) |
| #define SEG32_MODE32_DS (2 << 3) |
| #define SEG32_MODE16_CS (3 << 3) |
| #define SEG32_MODE16_DS (4 << 3) |
| #define SEG32_MODE16BIG_CS (5 << 3) |
| #define SEG32_MODE16BIG_DS (6 << 3) |
| |
| // Debugging levels. If non-zero and CONFIG_DEBUG_LEVEL is greater |
| // than the specified value, then the corresponding irq handler will |
| // report every enter event. |
| #define DEBUG_ISR_02 1 |
| #define DEBUG_HDL_05 1 |
| #define DEBUG_ISR_08 20 |
| #define DEBUG_ISR_09 9 |
| #define DEBUG_ISR_0e 9 |
| #define DEBUG_HDL_10 20 |
| #define DEBUG_HDL_11 2 |
| #define DEBUG_HDL_12 2 |
| #define DEBUG_HDL_13 10 |
| #define DEBUG_HDL_14 2 |
| #define DEBUG_HDL_15 9 |
| #define DEBUG_HDL_16 9 |
| #define DEBUG_HDL_17 2 |
| #define DEBUG_HDL_18 1 |
| #define DEBUG_HDL_19 1 |
| #define DEBUG_HDL_1a 9 |
| #define DEBUG_HDL_40 1 |
| #define DEBUG_ISR_70 9 |
| #define DEBUG_ISR_74 9 |
| #define DEBUG_ISR_75 1 |
| #define DEBUG_ISR_76 10 |
| #define DEBUG_ISR_hwpic1 5 |
| #define DEBUG_ISR_hwpic2 5 |
| #define DEBUG_HDL_smi 9 |
| #define DEBUG_HDL_smp 1 |
| #define DEBUG_HDL_pnp 1 |
| #define DEBUG_HDL_pmm 1 |
| #define DEBUG_HDL_pcibios 9 |
| #define DEBUG_HDL_apm 9 |
| |
| #define DEBUG_unimplemented 2 |
| #define DEBUG_invalid 3 |
| #define DEBUG_thread 2 |
| #define DEBUG_tcg 20 |
| |
| #endif // config.h |