| chip northbridge/intel/sandybridge |
| register "gfx" = "GMA_STATIC_DISPLAYS(1)" |
| |
| # Enable DisplayPort Hotplug with 6ms pulse |
| register "gpu_dp_d_hotplug" = "0x06" |
| |
| # Enable Panel as LVDS and configure power delays |
| register "gpu_panel_port_select" = "PANEL_PORT_LVDS" |
| register "gpu_panel_power_cycle_delay" = "6" # T7: 500ms |
| register "gpu_panel_power_up_delay" = "100" # T1+T2: 10ms |
| register "gpu_panel_power_down_delay" = "100" # T5+T6: 10ms |
| register "gpu_panel_power_backlight_on_delay" = "2100" # T3: 210ms |
| register "gpu_panel_power_backlight_off_delay" = "2100" # T4: 210ms |
| register "gpu_cpu_backlight" = "0x1155" |
| register "gpu_pch_backlight" = "0x11551155" |
| |
| register "spd_addresses" = "{0x50, 0, 0x51, 0}" |
| |
| device domain 0 on |
| subsystemid 0x17aa 0x21f3 inherit |
| |
| chip southbridge/intel/bd82x6x # Intel Series 6 Cougar Point PCH |
| register "docking_supported" = "1" |
| register "gen1_dec" = "0x000c15e1" |
| register "gen2_dec" = "0x007c1601" |
| register "gen3_dec" = "0x000c06a1" |
| register "gpi13_routing" = "2" |
| register "gpi1_routing" = "2" |
| register "pcie_hotplug_map" = "{ 0, 0, 1, 0, 0, 0, 0, 0 }" |
| register "pcie_port_coalesce" = "true" |
| register "sata_interface_speed_support" = "0x3" |
| register "sata_port_map" = "0x17" |
| |
| # Do not enable xHCI Port 4 since WWAN USB is EHCI-only |
| register "superspeed_capable_ports" = "0x7" |
| register "xhci_switchable_ports" = "0x7" |
| register "xhci_overcurrent_mapping" = "0x04000201" |
| register "usb_port_config" = "{ |
| { 1, 1, 0 }, |
| { 1, 1, 1 }, |
| { 1, 2, 3 }, |
| { 1, 1, -1 }, |
| { 1, 1, 2 }, |
| { 1, 0, -1 }, |
| { 0, 0, -1 }, |
| { 1, 2, -1 }, |
| { 1, 0, -1 }, |
| { 1, 1, 5 }, |
| { 1, 0, -1 }, |
| { 1, 0, -1 }, |
| { 1, 3, -1 }, |
| { 1, 1, -1 } |
| }" |
| |
| # device specific SPI configuration |
| register "spi_uvscc" = "0x2005" |
| register "spi_lvscc" = "0x2005" |
| |
| device ref xhci on end # USB 3.0 Controller |
| device ref mei1 on end # Management Engine Interface 1 |
| device ref mei2 off end # Management Engine Interface 2 |
| device ref me_ide_r off end # Management Engine IDE-R |
| device ref me_kt off end # Management Engine KT |
| device ref gbe on end # Intel Gigabit Ethernet |
| device ref ehci2 on end # USB2 EHCI #2 |
| device ref hda on end # High Definition Audio controller |
| device ref pcie_rp1 on # PCIe Port #1 |
| chip drivers/ricoh/rce822 # Ricoh cardreader |
| register "disable_mask" = "0x87" |
| register "sdwppol" = "1" |
| device pci 00.0 on end # Ricoh SD card reader |
| end |
| end |
| device ref pcie_rp2 on end # PCIe Port #2 |
| device ref pcie_rp3 on # PCIe Port #3 |
| smbios_slot_desc "7" "3" "ExpressCard Slot" "8" |
| end |
| device ref pcie_rp4 off end # PCIe Port #4 |
| device ref pcie_rp5 off end # PCIe Port #5 |
| device ref pcie_rp6 off end # PCIe Port #6 |
| device ref pcie_rp7 off end # PCIe Port #7 |
| device ref pcie_rp8 off end # PCIe Port #8 |
| device ref ehci1 on end # USB2 EHCI #1 |
| device ref pci_bridge off end # PCI bridge |
| device ref lpc on # LPC bridge PCI-LPC bridge |
| chip ec/lenovo/pmh7 |
| register "backlight_enable" = "true" |
| register "dock_event_enable" = "true" |
| device pnp ff.1 on end # dummy |
| end |
| chip ec/lenovo/h8 |
| device pnp ff.2 on # dummy |
| io 0x60 = 0x62 |
| io 0x62 = 0x66 |
| io 0x64 = 0x1600 |
| io 0x66 = 0x1604 |
| end |
| register "config0" = "0xa7" |
| register "config1" = "0x01" |
| register "config2" = "0xa0" |
| register "config3" = "0xe2" |
| |
| register "has_keyboard_backlight" = "0" |
| |
| register "beepmask0" = "0x02" |
| register "beepmask1" = "0x86" |
| register "has_power_management_beeps" = "1" |
| register "event2_enable" = "0xff" |
| register "event3_enable" = "0xff" |
| register "event4_enable" = "0xf0" |
| register "event5_enable" = "0x3c" |
| register "event6_enable" = "0x00" |
| register "event7_enable" = "0xa1" |
| register "event8_enable" = "0x7b" |
| register "event9_enable" = "0xff" |
| register "eventa_enable" = "0x00" |
| register "eventb_enable" = "0x00" |
| register "eventc_enable" = "0xff" |
| register "eventd_enable" = "0xff" |
| register "evente_enable" = "0x0d" |
| |
| register "has_bdc_detection" = "1" |
| register "bdc_gpio_num" = "54" |
| register "bdc_gpio_lvl" = "0" |
| |
| register "has_wwan_detection" = "1" |
| register "wwan_gpio_num" = "70" |
| register "wwan_gpio_lvl" = "0" |
| end |
| chip drivers/lenovo/hybrid_graphics |
| device pnp ff.f on end # dummy |
| |
| register "detect_gpio" = "21" |
| |
| register "has_panel_hybrid_gpio" = "1" |
| register "panel_hybrid_gpio" = "52" |
| register "panel_integrated_lvl" = "1" |
| |
| register "has_backlight_gpio" = "0" |
| register "has_dgpu_power_gpio" = "0" |
| |
| register "has_thinker1" = "1" |
| end |
| chip drivers/pc80/tpm |
| device pnp 0c31.0 on end |
| end |
| end |
| device ref sata1 on end # SATA Controller 1 |
| device ref smbus on # SMBus |
| chip drivers/i2c/at24rf08c # eeprom, 8 virtual devices, same chip |
| device i2c 54 on end |
| device i2c 55 on end |
| device i2c 56 on end |
| device i2c 57 on end |
| device i2c 5c on end |
| device i2c 5d on end |
| device i2c 5e on end |
| device i2c 5f on end |
| end |
| end |
| device ref sata2 off end # SATA Controller 2 |
| device ref thermal off end # Thermal |
| end |
| device ref host_bridge on end # Host bridge Host bridge |
| device ref peg10 on end # PCIe Bridge for discrete graphics |
| device ref igd on end # Internal graphics VGA controller |
| device ref dev4 off end # Signal processing controller |
| end |
| end |