| /* SPDX-License-Identifier: GPL-2.0-only */ |
| |
| #include <stdint.h> |
| #include <stddef.h> |
| #include <device/pci_ops.h> |
| #include <console/uart.h> |
| #include <device/pci.h> |
| |
| static unsigned int oxpcie_present; |
| static DEVTREE_CONST u32 uart0_base = CONFIG_EARLY_PCI_MMIO_BASE + 0x1000; |
| |
| int pci_early_device_probe(u8 bus, u8 dev, u32 mmio_base) |
| { |
| pci_devfn_t device = PCI_DEV(bus, dev, 0); |
| |
| u32 id = pci_s_read_config32(device, PCI_VENDOR_ID); |
| switch (id) { |
| case 0xc1181415: /* e.g. Startech PEX1S1PMINI function 0 */ |
| /* On this device function 0 is the parallel port, and |
| * function 3 is the serial port. So let's go look for |
| * the UART. |
| */ |
| device = PCI_DEV(bus, dev, 3); |
| id = pci_s_read_config32(device, PCI_VENDOR_ID); |
| if (id != 0xc11b1415) |
| return -1; |
| break; |
| case 0xc11b1415: /* e.g. Startech PEX1S1PMINI function 3 */ |
| case 0xc1581415: /* e.g. Startech MPEX2S952 */ |
| break; |
| default: |
| /* No UART here. */ |
| return -1; |
| } |
| |
| /* Sanity-check, we assume fixed location. */ |
| if (mmio_base != CONFIG_EARLY_PCI_MMIO_BASE) |
| return -1; |
| |
| /* Setup base address on device */ |
| pci_s_write_config32(device, PCI_BASE_ADDRESS_0, mmio_base); |
| |
| /* Enable memory on device */ |
| u16 reg16 = pci_s_read_config16(device, PCI_COMMAND); |
| reg16 |= PCI_COMMAND_MEMORY; |
| pci_s_write_config16(device, PCI_COMMAND, reg16); |
| |
| oxpcie_present = 1; |
| return 0; |
| } |
| |
| static int oxpcie_uart_active(void) |
| { |
| return oxpcie_present; |
| } |
| |
| uintptr_t uart_platform_base(unsigned int idx) |
| { |
| if ((idx < 8) && oxpcie_uart_active()) |
| return uart0_base + idx * 0x200; |
| return 0; |
| } |
| |
| void oxford_remap(u32 new_base) |
| { |
| #if ENV_RAMSTAGE |
| uart0_base = new_base + 0x1000; |
| #endif |
| } |
| |
| unsigned int uart_platform_refclk(void) |
| { |
| return 62500000; |
| } |