| /* SPDX-License-Identifier: GPL-2.0-or-later */ |
| |
| #include <device/pci.h> |
| #include <intelblocks/lpc_lib.h> |
| #include <intelblocks/rtc.h> |
| #include <soc/gpio.h> |
| #include <soc/pcr_ids.h> |
| #include <soc/pm.h> |
| #include "chip.h" |
| |
| static const struct lpc_mmio_range apl_lpc_fixed_mmio_ranges[] = { |
| { 0xfed40000, 0x8000 }, |
| { 0xfedc0000, 0x4000 }, |
| { 0xfed20800, 16 }, |
| { 0xfed20880, 8 }, |
| { 0xfed208e0, 16 }, |
| { 0xfed208f0, 8 }, |
| { 0xfed30800, 16 }, |
| { 0xfed30880, 8 }, |
| { 0xfed308e0, 16 }, |
| { 0xfed308f0, 8 }, |
| { 0, 0 } |
| }; |
| |
| const struct lpc_mmio_range *soc_get_fixed_mmio_ranges(void) |
| { |
| return apl_lpc_fixed_mmio_ranges; |
| } |
| |
| static const struct pad_config lpc_gpios[] = { |
| #if CONFIG(SOC_INTEL_GEMINILAKE) |
| #if !CONFIG(SOC_ESPI) |
| PAD_CFG_NF(GPIO_147, UP_20K, DEEP, NF1), /* LPC_ILB_SERIRQ */ |
| PAD_CFG_NF_IOSSTATE_IOSTERM(GPIO_148, NONE, DEEP, NF1, HIZCRx1, |
| DISPUPD), /* LPC_CLKOUT0 */ |
| PAD_CFG_NF_IOSSTATE_IOSTERM(GPIO_149, NONE, DEEP, NF1, HIZCRx1, |
| DISPUPD), /* LPC_CLKOUT1 */ |
| PAD_CFG_NF_IOSSTATE_IOSTERM(GPIO_150, UP_20K, DEEP, NF1, HIZCRx1, |
| DISPUPD), /* LPC_AD0 */ |
| PAD_CFG_NF_IOSSTATE_IOSTERM(GPIO_151, UP_20K, DEEP, NF1, HIZCRx1, |
| DISPUPD), /* LPC_AD1 */ |
| PAD_CFG_NF_IOSSTATE_IOSTERM(GPIO_152, UP_20K, DEEP, NF1, HIZCRx1, |
| DISPUPD), /* LPC_AD2 */ |
| PAD_CFG_NF_IOSSTATE_IOSTERM(GPIO_153, UP_20K, DEEP, NF1, HIZCRx1, |
| DISPUPD), /* LPC_AD3 */ |
| PAD_CFG_NF(GPIO_154, UP_20K, DEEP, NF1), /* LPC_CLKRUNB */ |
| PAD_CFG_NF_IOSSTATE_IOSTERM(GPIO_155, UP_20K, DEEP, NF1, HIZCRx1, |
| DISPUPD), /* LPC_FRAMEB */ |
| #else |
| /* |
| * LPC_CLKRUNB should be in GPIO mode for eSPI. Other pin settings |
| * i.e. Rx path enable/disable, Tx path enable/disable, pull up |
| * enable/disable etc are ignored. Leaving this pin in Native mode |
| * will keep LPC Controller awake and prevent S0ix entry |
| */ |
| PAD_NC(GPIO_154, NONE), |
| #endif /* !CONFIG(SOC_ESPI) */ |
| #else |
| PAD_CFG_NF(LPC_ILB_SERIRQ, UP_20K, DEEP, NF1), |
| PAD_CFG_NF(LPC_CLKRUNB, UP_20K, DEEP, NF1), |
| PAD_CFG_NF(LPC_AD0, UP_20K, DEEP, NF1), |
| PAD_CFG_NF(LPC_AD1, UP_20K, DEEP, NF1), |
| PAD_CFG_NF(LPC_AD2, UP_20K, DEEP, NF1), |
| PAD_CFG_NF(LPC_AD3, UP_20K, DEEP, NF1), |
| PAD_CFG_NF(LPC_FRAMEB, NATIVE, DEEP, NF1), |
| PAD_CFG_NF(LPC_CLKOUT0, UP_20K, DEEP, NF1), |
| PAD_CFG_NF(LPC_CLKOUT1, UP_20K, DEEP, NF1) |
| #endif |
| }; |
| |
| void lpc_configure_pads(void) |
| { |
| gpio_configure_pads(lpc_gpios, ARRAY_SIZE(lpc_gpios)); |
| } |
| |
| void lpc_soc_init(struct device *dev) |
| { |
| const struct soc_intel_apollolake_config *cfg; |
| cfg = config_of(dev); |
| |
| /* Set LPC Serial IRQ mode */ |
| lpc_set_serirq_mode(cfg->serirq_mode); |
| |
| /* Initialize RTC */ |
| rtc_init(); |
| } |