| /* SPDX-License-Identifier: GPL-2.0-or-later */ |
| |
| #include <stdint.h> |
| #include <commonlib/helpers.h> |
| #include <device/device.h> |
| #include <device/mmio.h> |
| #include <device/pci_def.h> |
| #include <intelblocks/graphics.h> |
| #include <drivers/intel/gma/i915_reg.h> |
| |
| #include "chip.h" |
| |
| static void graphics_configure_panelpower( |
| const struct soc_intel_apl_pp *const pp, |
| uint8_t *const mmio, const unsigned int panel_idx) |
| { |
| const unsigned int offset = panel_idx * 0x100; |
| uint32_t reg32; |
| |
| reg32 = ((DIV_ROUND_UP(pp->cycle_delay_ms, 100) + 1) & 0x1f) | PANEL_POWER_RESET; |
| write32(mmio + PCH_PP_CONTROL + offset, reg32); |
| |
| reg32 = pp->up_delay_ms * 10 << 16; |
| reg32 |= pp->backlight_on_delay_ms * 10; |
| write32(mmio + PCH_PP_ON_DELAYS + offset, reg32); |
| |
| reg32 = pp->down_delay_ms * 10 << 16; |
| reg32 |= pp->backlight_off_delay_ms * 10; |
| write32(mmio + PCH_PP_OFF_DELAYS + offset, reg32); |
| } |
| |
| static void graphics_configure_backlight( |
| const struct soc_intel_apl_blc *const blc, |
| uint8_t *const mmio, const unsigned int panel_idx) |
| { |
| if (!blc->pwm_hz) |
| return; |
| |
| const unsigned int pwm_period = 19200 * 1000 / blc->pwm_hz; |
| write32(mmio + BXT_BLC_PWM_FREQ(panel_idx), pwm_period); |
| write32(mmio + BXT_BLC_PWM_DUTY(panel_idx), pwm_period / 2); |
| write32(mmio + BXT_BLC_PWM_CTL(panel_idx), |
| (blc->polarity ? BXT_BLC_PWM_POLARITY : 0)); |
| |
| /* Second backlight control uses display utility pin. */ |
| if (panel_idx == 1) { |
| write32(mmio + UTIL_PIN_CTL, 0); /* Make sure it's disabled, don't know |
| what FSP might have done already. */ |
| write32(mmio + UTIL_PIN_CTL, UTIL_PIN_MODE_PWM | UTIL_PIN_ENABLE); |
| } |
| } |
| |
| void graphics_soc_init(struct device *const dev) |
| { |
| const struct soc_intel_apollolake_config *const conf = dev->chip_info; |
| const struct resource *mmio_res; |
| void *mmio; |
| unsigned int i; |
| |
| /* Some hardware configuration first. */ |
| |
| if (!conf) |
| return; |
| |
| mmio_res = probe_resource(dev, PCI_BASE_ADDRESS_0); |
| if (!mmio_res || !mmio_res->base) |
| return; |
| mmio = (void *)(uintptr_t)mmio_res->base; |
| |
| for (i = 0; i < ARRAY_SIZE(conf->gpu_pp); ++i) |
| graphics_configure_panelpower(&conf->gpu_pp[i], mmio, i); |
| |
| for (i = 0; i < ARRAY_SIZE(conf->gpu_blc); ++i) |
| graphics_configure_backlight(&conf->gpu_blc[i], mmio, i); |
| } |