| /* SPDX-License-Identifier: GPL-2.0-only */ |
| |
| #include <bootblock_common.h> |
| #include <stdint.h> |
| #include <arch/io.h> |
| #include <superio/smsc/sio1007/sio1007.h> |
| #include <southbridge/intel/bd82x6x/pch.h> |
| |
| #define SIO_PORT 0x164e |
| |
| void bootblock_mainboard_early_init(void) |
| { |
| const u16 port = SIO_PORT; |
| const u16 runtime_port = 0x180; |
| |
| /* Enable COM1 if requested */ |
| if (CONFIG(DRIVERS_UART_8250IO)) |
| sio1007_enable_uart_at(port); |
| |
| /* Turn on configuration mode. */ |
| outb(0x55, port); |
| |
| /* Set the GPIO direction, polarity, and type. */ |
| sio1007_setreg(port, 0x31, 1 << 0, 1 << 0); |
| sio1007_setreg(port, 0x32, 0 << 0, 1 << 0); |
| sio1007_setreg(port, 0x33, 0 << 0, 1 << 0); |
| |
| /* Set the base address for the runtime register block. */ |
| sio1007_setreg(port, 0x30, runtime_port >> 4, 0xff); |
| sio1007_setreg(port, 0x21, runtime_port >> 12, 0xff); |
| |
| /* Turn on address decoding for it. */ |
| sio1007_setreg(port, 0x3a, 1 << 1, 1 << 1); |
| |
| /* Set the value of GPIO 10 by changing GP1, bit 0. */ |
| u8 byte; |
| byte = inb(runtime_port + 0xc); |
| byte |= (1 << 0); |
| outb(byte, runtime_port + 0xc); |
| |
| /* Turn off address decoding for it. */ |
| sio1007_setreg(port, 0x3a, 0 << 1, 1 << 1); |
| |
| /* Turn off configuration mode. */ |
| outb(0xaa, port); |
| } |