| chip northbridge/intel/haswell |
| |
| register "panel_cfg" = "{ |
| .up_delay_ms = 40, |
| .down_delay_ms = 15, |
| .cycle_delay_ms = 400, |
| .backlight_on_delay_ms = 210, |
| .backlight_off_delay_ms = 210, |
| .backlight_pwm_hz = 200, |
| }" |
| |
| device domain 0 on |
| |
| chip southbridge/intel/lynxpoint |
| |
| register "sata_devslp_disable" = "0x1" |
| |
| # DTLE DATA / EDGE values |
| register "sata_port0_gen3_dtle" = "0x5" |
| register "sata_port1_gen3_dtle" = "0x5" |
| |
| # Disable PCIe CLKOUT 2-5 and CLKOUT_XDP |
| register "icc_clock_disable" = "0x013c0000" |
| |
| device pci 1f.3 on # SMBus |
| chip drivers/i2c/rtd2132 |
| # Panel Power Timings (1 ms units) |
| # Note: the panel Tx timings are very |
| # different from the LVDS bridge |
| # Tx timing settings. Below is a mapping |
| # for RTD2132 -> Panel timings. |
| # T1 = T2 |
| # T2 = T8 + T10 + T12 |
| # T3 = T14 |
| # T4 = T15 |
| # T5 = T9 + T11 + T13 |
| # T6 = T3 |
| # T7 = T4 |
| register "t1" = "0x14" |
| register "t2" = "0xdc" |
| register "t3" = "0x0e" |
| register "t4" = "0x02" |
| register "t5" = "0xdc" |
| register "t6" = "0x14" |
| register "t7" = "0x208" |
| # LVDS Swap settings are normal. |
| register "lvds_swap" = "0" |
| # Enable Spread Sprectrum at 0.5% |
| register "sscg_percent" = "0x05" |
| device i2c 35 on end # (8bit address: 0x6A) |
| end # rtd2132 |
| end # SMBus |
| end |
| end |
| end |