| /* SPDX-License-Identifier: GPL-2.0-only */ |
| |
| #include <amdblocks/acpimmio.h> |
| #include <amdblocks/espi.h> |
| #include <amdblocks/lpc.h> |
| #include <amdblocks/smbus.h> |
| #include <amdblocks/i2c.h> |
| #include <console/console.h> |
| #include <soc/i2c.h> |
| #include <soc/southbridge.h> |
| #include <soc/uart.h> |
| |
| #include "chip.h" |
| |
| /* This table is for the initial conversion of all SCL pins to input with no pull. */ |
| static const struct soc_i2c_scl_pin i2c_scl_pins[] = { |
| { PAD_GPI(I2C0_SCL_PIN, PULL_NONE), GPIO_I2C0_SCL }, |
| { PAD_GPI(I2C1_SCL_PIN, PULL_NONE), GPIO_I2C1_SCL }, |
| { PAD_GPI(I2C2_SCL_PIN, PULL_NONE), GPIO_I2C2_SCL }, |
| { PAD_GPI(I2C3_SCL_PIN, PULL_NONE), GPIO_I2C3_SCL }, |
| }; |
| |
| static void reset_i2c_peripherals(void) |
| { |
| const struct soc_amd_cezanne_config *cfg = config_of_soc(); |
| struct soc_i2c_peripheral_reset_info reset_info; |
| |
| reset_info.i2c_scl_reset_mask = cfg->i2c_scl_reset & GPIO_I2C_MASK; |
| reset_info.i2c_scl = i2c_scl_pins; |
| reset_info.num_pins = ARRAY_SIZE(i2c_scl_pins); |
| sb_reset_i2c_peripherals(&reset_info); |
| } |
| |
| /* Before console init */ |
| void fch_pre_init(void) |
| { |
| lpc_early_init(); |
| |
| enable_acpimmio_decode_pm04(); |
| fch_smbus_init(); |
| fch_enable_cf9_io(); |
| fch_enable_legacy_io(); |
| fch_disable_legacy_dma_io(); |
| enable_aoac_devices(); |
| reset_i2c_peripherals(); |
| |
| /* |
| * On reset Range_0 defaults to enabled. We want to start with a clean |
| * slate to not have things unexpectedly enabled. |
| */ |
| clear_uart_legacy_config(); |
| |
| if (CONFIG(AMD_SOC_CONSOLE_UART)) |
| set_uart_config(CONFIG_UART_FOR_CONSOLE); |
| } |
| |
| /* After console init */ |
| void fch_early_init(void) |
| { |
| fch_print_pmxc0_status(); |
| i2c_soc_early_init(); |
| |
| if (CONFIG(DISABLE_SPI_FLASH_ROM_SHARING)) |
| lpc_disable_spi_rom_sharing(); |
| |
| if (CONFIG(SOC_AMD_COMMON_BLOCK_USE_ESPI)) { |
| espi_setup(); |
| espi_configure_decodes(); |
| } |
| } |