| /* SPDX-License-Identifier: GPL-2.0-only */ |
| |
| #include <bootstate.h> |
| #include <console/console.h> |
| #include <device/device.h> |
| #include <device/mmio.h> |
| #include <intelblocks/acpi.h> |
| #include <intelblocks/pmc.h> |
| #include <intelblocks/pmclib.h> |
| #include <intelblocks/rtc.h> |
| #include <soc/pci_devs.h> |
| #include <soc/pm.h> |
| #include <soc/soc_chip.h> |
| |
| static void config_deep_sX(uint32_t offset, uint32_t mask, int sx, int enable) |
| { |
| uint32_t reg; |
| uint8_t *pmcbase = pmc_mmio_regs(); |
| |
| printk(BIOS_DEBUG, "%sabling Deep S%c\n", |
| enable ? "En" : "Dis", sx + '0'); |
| reg = read32(pmcbase + offset); |
| if (enable) |
| reg |= mask; |
| else |
| reg &= ~mask; |
| write32(pmcbase + offset, reg); |
| } |
| |
| static void config_deep_s5(int on_ac, int on_dc) |
| { |
| /* Treat S4 the same as S5. */ |
| config_deep_sX(S4_PWRGATE_POL, S4AC_GATE_SUS, 4, on_ac); |
| config_deep_sX(S4_PWRGATE_POL, S4DC_GATE_SUS, 4, on_dc); |
| config_deep_sX(S5_PWRGATE_POL, S5AC_GATE_SUS, 5, on_ac); |
| config_deep_sX(S5_PWRGATE_POL, S5DC_GATE_SUS, 5, on_dc); |
| } |
| |
| static void config_deep_s3(int on_ac, int on_dc) |
| { |
| config_deep_sX(S3_PWRGATE_POL, S3AC_GATE_SUS, 3, on_ac); |
| config_deep_sX(S3_PWRGATE_POL, S3DC_GATE_SUS, 3, on_dc); |
| } |
| |
| static void config_deep_sx(uint32_t deepsx_config) |
| { |
| uint32_t reg; |
| uint8_t *pmcbase = pmc_mmio_regs(); |
| |
| reg = read32(pmcbase + DSX_CFG); |
| reg &= ~DSX_CFG_MASK; |
| reg |= deepsx_config; |
| write32(pmcbase + DSX_CFG, reg); |
| } |
| |
| static void soc_pmc_enable(struct device *dev) |
| { |
| const config_t *config = config_of_soc(); |
| |
| rtc_init(); |
| |
| pmc_set_power_failure_state(true); |
| pmc_gpe_init(); |
| |
| config_deep_s3(config->deep_s3_enable_ac, config->deep_s3_enable_dc); |
| config_deep_s5(config->deep_s5_enable_ac, config->deep_s5_enable_dc); |
| config_deep_sx(config->deep_sx_config); |
| } |
| |
| static void soc_pmc_read_resources(struct device *dev) |
| { |
| struct resource *res; |
| |
| mmio_resource(dev, 0, PCH_PWRM_BASE_ADDRESS / KiB, PCH_PWRM_BASE_SIZE / KiB); |
| |
| res = new_resource(dev, 1); |
| res->base = (resource_t)ACPI_BASE_ADDRESS; |
| res->size = (resource_t)ACPI_BASE_SIZE; |
| res->limit = res->base + res->size + 1; |
| res->flags = IORESOURCE_IO | IORESOURCE_ASSIGNED | IORESOURCE_FIXED; |
| } |
| |
| static void soc_pmc_init(struct device *dev) |
| { |
| /* |
| * pmc_set_acpi_mode() should be delayed until BS_DEV_INIT in order |
| * to ensure the ordering does not break the assumptions that other |
| * drivers make about ACPI mode (e.g. Chrome EC). Since it disables |
| * ACPI mode, other drivers may take different actions based on this |
| * (e.g. Chrome EC will flush any pending hostevent bits). Because |
| * EHL has its PMC device available for device_operations, it can be |
| * done from the "ops->init" callback. |
| */ |
| pmc_set_acpi_mode(); |
| } |
| |
| static void pmc_fill_ssdt(const struct device *dev) |
| { |
| if (CONFIG(SOC_INTEL_COMMON_BLOCK_ACPI_PEP)) |
| generate_acpi_power_engine(); |
| } |
| |
| struct device_operations pmc_ops = { |
| .read_resources = soc_pmc_read_resources, |
| .set_resources = noop_set_resources, |
| .init = soc_pmc_init, |
| .enable = soc_pmc_enable, |
| #if CONFIG(HAVE_ACPI_TABLES) |
| .acpi_fill_ssdt = pmc_fill_ssdt, |
| #endif |
| }; |