setup for v2
git-svn-id: svn://svn.coreboot.org/coreboot/trunk@1278 2b7e53f0-3cfb-0310-b3e9-8179ed1497e1
diff --git a/targets/motorola/sandpoint/Config.lb b/targets/motorola/sandpoint/Config.lb
index b725ab4..4163fe3 100644
--- a/targets/motorola/sandpoint/Config.lb
+++ b/targets/motorola/sandpoint/Config.lb
@@ -19,17 +19,18 @@
uses CONFIG_IDE_STREAM
uses IDE_BOOT_DRIVE
uses IDE_SWAB IDE_OFFSET
-uses ROM_SIZE ROM_IMAGE_SIZE
-uses ROM_SECTION_SIZE
-uses ROM_SECTION_OFFSET
+uses ROM_SIZE
uses _RESET
uses _EXCEPTION_VECTORS
uses _ROMBASE
+uses _ROMSTART
uses _RAMBASE
-uses STACK_SIZE HEAP_SIZE
+uses _RAMSTART
+uses STACK_SIZE
+uses HEAP_SIZE
## use a cross compiler
-option CROSS_COMPILE="powerpc-eabi-"
+#option CROSS_COMPILE="powerpc-eabi-"
#option CROSS_COMPILE="ppc_74xx-"
## Use stage 1 initialization code
@@ -44,8 +45,8 @@
## Enable serial console
option DEFAULT_CONSOLE_LOGLEVEL=8
option CONFIG_CONSOLE_SERIAL8250=1
-option TTYS0_BASE=0x3f0
-option UART0_IO_BASE=0xfe000000+TTYS0_BASE
+option UART0_IO_BASE=0x3f0
+option TTYS0_BASE=0xfe000000+UART0_IO_BASE
## Boot linux from IDE
option CONFIG_IDE_STREAM=1
@@ -53,46 +54,32 @@
option IDE_SWAB=1
option IDE_OFFSET=0
+# ROM is 1Mb
option ROM_SIZE=1048576
-## For the trick of using cache as ram
-## put the fake ram location at this address
-#option CACHE_RAM_BASE=0x00200000
-#option CACHE_RAM_SIZE=0x00004000
-
-##
-## Use a 64K stack
-##
+# Set stack and heap sizes (stage 2)
option STACK_SIZE=0x10000
-
-##
-## Use a 64K heap
-##
option HEAP_SIZE=0x10000
-## Compute the location and size of where this firmware image
-## (linuxBIOS plus bootloader) will live in the boot rom chip.
-##
-option ROM_SECTION_SIZE=ROM_SIZE
-option ROM_SECTION_OFFSET=0
-
# Sandpoint Demo Board
romimage "normal"
- ## Sandpoint reset vector
- option _RESET=0xfff00100
+ ## Base of ROM
+ option _ROMBASE=0xfff00000
- ## Excpetoion vectors
+ ## Sandpoint reset vector
+ option _RESET=_ROMBASE+0x100
+
+ ## Exception vectors (other than reset vector)
option _EXCEPTION_VECTORS=_RESET+0x100
## Start of linuxBIOS in the boot rom
## = _RESET + exeception vector table size
- option _ROMBASE=0xfff03100
+ option _ROMSTART=_RESET+0x3100
## LinuxBIOS C code runs at this location in RAM
option _RAMBASE=0x00100000
+ option _RAMSTART=0x00100000
- ## ROM_IMAGE_SIZE is the amount of space to allow linuxBIOS to occupy.
- option ROM_IMAGE_SIZE=49152
option CONFIG_SANDPOINT_ALTIMUS=1
mainboard motorola/sandpoint