| chip soc/intel/skylake |
| |
| # Mapping of USB port # to device |
| #+----------------+-------+-----------------------------------+ |
| #| Device | Port# | Rev | |
| #+----------------+-------+-----------------------------------+ |
| #| USB A Side | 3 | 2/3 | |
| #| SD Card | 4 | | |
| #| Camera | 8 | | |
| #| Touchsreen | 10 | | |
| #+----------------+-------+-----------------------------------+ |
| register "usb2_ports[2]" = "USB2_PORT_MID(OC2)" # Type-A Side |
| register "usb2_ports[3]" = "USB2_PORT_MID(OC_SKIP)" # Card reader |
| register "usb2_ports[7]" = "USB2_PORT_MID(OC_SKIP)" # Camera |
| register "usb2_ports[9]" = "USB2_PORT_MID(OC_SKIP)" # Touchscreen |
| |
| register "usb3_ports[2]" = "USB3_PORT_DEFAULT(OC2)" # Type-A Side |
| register "usb3_ports[3]" = "USB3_PORT_DEFAULT(OC_SKIP)" # Card reader |
| |
| register "power_limits_config" = "{ |
| .psys_pmax = 151, |
| }" |
| |
| device domain 0 on |
| device pci 14.0 on |
| chip drivers/usb/acpi |
| device usb 0.0 on |
| chip drivers/usb/acpi |
| register "desc" = ""USB2 Type-A Side"" |
| register "type" = "UPC_TYPE_A" |
| device usb 2.2 on end |
| end |
| chip drivers/usb/acpi |
| register "desc" = ""USB2 SD Card"" |
| register "type" = "UPC_TYPE_INTERNAL" |
| device usb 2.3 on end |
| end |
| chip drivers/usb/acpi |
| register "desc" = ""USB2 Camera"" |
| register "type" = "UPC_TYPE_INTERNAL" |
| device usb 2.7 on end |
| end |
| chip drivers/usb/acpi |
| register "desc" = ""USB2 Touchscreen"" |
| register "type" = "UPC_TYPE_INTERNAL" |
| device usb 2.9 on end |
| end |
| chip drivers/usb/acpi |
| register "desc" = ""USB3 Type-A Side"" |
| register "type" = "UPC_TYPE_USB3_A" |
| device usb 3.2 on end |
| end |
| chip drivers/usb/acpi |
| register "desc" = ""USB3 SD Card"" |
| register "type" = "UPC_TYPE_INTERNAL" |
| device usb 3.3 on end |
| end |
| end |
| end |
| end # USB xHCI |
| device pci 19.1 on |
| chip drivers/generic/max98357a |
| register "hid" = ""MX98357A"" |
| register "sdmode_gpio" = "ACPI_GPIO_OUTPUT_ACTIVE_HIGH(GPP_A23)" |
| register "sdmode_delay" = "5" |
| device generic 0 on end |
| end |
| chip drivers/i2c/da7219 |
| register "irq" = "ACPI_IRQ_LEVEL_LOW(GPP_D9_IRQ)" |
| register "btn_cfg" = "50" |
| register "mic_det_thr" = "500" |
| register "jack_ins_deb" = "20" |
| register "jack_det_rate" = ""32ms_64ms"" |
| register "jack_rem_deb" = "1" |
| register "a_d_btn_thr" = "0xa" |
| register "d_b_btn_thr" = "0x16" |
| register "b_c_btn_thr" = "0x21" |
| register "c_mic_btn_thr" = "0x3e" |
| register "btn_avg" = "4" |
| register "adc_1bit_rpt" = "1" |
| register "micbias_lvl" = "2600" |
| register "mic_amp_in_sel" = ""diff"" |
| device i2c 1a on end |
| end |
| end # I2C #5 |
| device pci 1e.6 off end # SDCard |
| end |
| end |