| # SPDX-License-Identifier: GPL-2.0-only |
| |
| # Memory chip: Hynix H5TQ4G63MFR-PBC with ECC |
| # BAP ODE E20XX has 2GB RAM soldered down on the Q7 |
| # Memory setting for DDR-1066 |
| |
| # 0 Number of SPD Bytes used / Total SPD Size / CRC Coverage |
| # bits[3:0]: 1 = 128 SPD Bytes Used |
| # bits[6:4]: 1 = 256 SPD Bytes Total |
| # bit7 : 0 = CRC covers bytes 0 ~ 125 |
| 11 |
| |
| # 1 SPD Revision - |
| # 0x12 = Revision 1.2 |
| 12 |
| |
| # 2 Key Byte / DRAM Device Type |
| # bits[7:0]: 0x0b = DDR3 SDRAM |
| 0B |
| |
| # 3 Key Byte / Module Type |
| # bits[3:0]: 3 = SO-DIMM |
| # bits[7:4]: reserved |
| 03 |
| |
| # 4 SDRAM CHIP Density and Banks |
| # bits[3:0]: 4 = 4 Gigabits Total SDRAM capacity per chip |
| # bits[6:4]: 0 = 3 (8 banks) |
| # bit7 : reserved |
| 04 |
| |
| # 5 SDRAM Addressing |
| # bits[2:0]: 1 = 10 Column Address Bits |
| # bits[5:3]: 3 = 15 Row Address Bits |
| # bits[7:6]: reserved |
| 19 |
| |
| # 6 Module Nominal Voltage, VDD |
| # bit0 : 0 = 1.5 V operable |
| # bit1 : 0 = NOT 1.35 V operable |
| # bit2 : 0 = NOT 1.25 V operable |
| # bits[7:3]: reserved |
| 00 |
| |
| # 7 Module Organization |
| # bits[2:0]: 2 = 16 bits |
| # bits[5:3]: 0 = 1 Rank |
| # bits[7:6]: reserved |
| 02 |
| |
| # 8 Module Memory Bus Width |
| # bits[2:0]: 3 = Primary bus width is 64 bits |
| # bits[4:3]: 1 = 1 bit (bus width extension ECC) |
| # bits[7:5]: reserved |
| 0B |
| |
| # 9 Fine Timebase (FTB) Dividend / Divisor |
| # bits[3:0]: 0x01 divisor |
| # bits[7:4]: 0x01 dividend |
| # 1/1 = 1ps |
| 11 |
| |
| # 10 Medium Timebase (MTB) Dividend |
| # 11 Medium Timebase (MTB) Divisor |
| # 1 / 8 = .125 ns - used for DDR3 |
| 01 08 |
| |
| # 12 SDRAM Minimum Cycle Time (tCKmin) |
| # 0x0F = tCKmin of 1.875 ns = DDR3-1066 (533 MHz clock) |
| 0F |
| |
| # 13 Reserved |
| 00 |
| |
| # 14 CAS Latencies Supported, Least Significant Byte |
| # 15 CAS Latencies Supported, Most Significant Byte |
| # Cas Latencies of 8 - 5 are supported |
| 1E 00 |
| |
| # 16 Minimum CAS Latency Time (tAAmin) |
| # 0x69 = 13.125ns - DDR3-1066F |
| 69 |
| |
| # 17 Minimum Write Recovery Time (tWRmin) |
| # 0x78 = tWR of 15ns - All DDR3 speed grades |
| 78 |
| |
| # 18 Minimum RAS# to CAS# Delay Time (tRCDmin) |
| # 0x69 = 13.125ns - DDR3-1066F |
| 69 |
| |
| # 19 Minimum Row Active to Row Active Delay Time (tRRDmin) |
| # 0x3C = 7.5ns |
| 3C |
| |
| # 20 Minimum Row Precharge Delay Time (tRPmin) |
| # 0x69 = 13.125ns - DDR3-1066F |
| 69 |
| |
| # 21 Upper Nibbles for tRAS and tRC |
| # bits[3:0]: tRAS most significant nibble = 1 (see byte 22) |
| # bits[7:4]: tRC most significant nibble = 1 (see byte 23) |
| 11 |
| |
| # 22 Minimum Active to Precharge Delay Time (tRASmin), LSB |
| # 0x12C = 37.5ns - DDR3-1066 (see byte 21) |
| 2C |
| |
| # 23 Minimum Active to Active/Refresh Delay Time (tRCmin), LSB |
| # 0x195 = 50.625ns - DDR3-1066F (see byte 21) |
| 95 |
| |
| # 24 Minimum Refresh Recovery Delay Time (tRFCmin), LSB |
| # 25 Minimum Refresh Recovery Delay Time (tRFCmin), MSB |
| # 0x500 = 160ns - for 2 Gigabit chips |
| 80 07 |
| |
| # 26 Minimum Internal Write to Read Command Delay Time (tWTRmin) |
| # 0x3c = 7.5 ns - All DDR3 SDRAM speed bins |
| 3C |
| |
| # 27 Minimum Internal Read to Precharge Command Delay Time (tRTPmin) |
| # 0x3c = 7.5ns - All DDR3 SDRAM speed bins |
| 3C |
| |
| # 28 Upper Nibble for tFAWmin |
| # 29 Minimum Four Activate Window Delay Time (tFAWmin) |
| # 0x0190 = 50ns - DDR3-1066, 2 KB page size |
| 01 90 |
| |
| # 30 SDRAM Optional Feature |
| # bit0 : 1= RZQ/6 supported |
| # bit1 : 1 = RZQ/7 supported |
| # bits[6:2]: reserved |
| # bit7 : 0 = DLL Off mode supported |
| 03 |
| |
| # 31 SDRAM Thermal and Refresh Options |
| # bit0 : 0 = Temp up to 95c supported |
| # bit1 : 0 = 85-95c uses 2x refresh rate |
| # bit2 : 1 = Auto Self Refresh supported |
| # bit3 : 0 = no on die thermal sensor |
| # bits[6:4]: reserved |
| # bit7 : 0 = partial self refresh supported |
| 04 |
| |
| # 32 Module Thermal Sensor |
| # 0 = Thermal sensor not incorporated onto this assembly |
| 00 |
| |
| # 33 SDRAM Device Type |
| # bits[1:0]: 0 = Signal Loading not specified |
| # bits[3:2]: reserved |
| # bits[6:4]: 0 = Die count not specified |
| # bit7 : 0 = Standard Monolithic DRAM Device |
| 00 |
| |
| # 34 Fine Offset for SDRAM Minimum Cycle Time (tCKmin) |
| # 35 Fine Offset for Minimum CAS Latency Time (tAAmin) |
| # 36 Fine Offset for Minimum RAS# to CAS# Delay Time (tRCDmin) |
| # 37 Fine Offset for Minimum Row Precharge Delay Time (tRPmin) |
| # 38 Fine Offset for Minimum Active to Active/Refresh Delay (tRCmin) |
| 00 00 00 00 00 |
| |
| # 39 - 59 (reserved) |
| 00 00 00 00 00 00 00 00 |
| 00 00 00 00 00 00 00 00 |
| 00 00 00 00 00 |
| |
| # 60 Raw Card Extension, Module Nominal Height |
| # bits[4:0]: 0 = <= 15mm tall |
| # bits[7:5]: 0 = raw card revision 0-3 |
| 00 |
| |
| # 61 Module Maximum Thickness |
| # bits[3:0]: 0 = thickness front <= 1mm |
| # bits[7:4]: 0 = thinkness back <= 1mm |
| 00 |
| |
| # 62 Reference Raw Card Used |
| # bits[4:0]: 0 = Reference Raw card A used |
| # bits[6:5]: 0 = revision 0 |
| # bit7 : 0 = Reference raw cards A through AL |
| 00 |
| |
| # 63 Address Mapping from Edge Connector to DRAM |
| # bit0 : 0 = standard mapping (not mirrored) |
| # bits[7:1]: reserved |
| 00 |
| |
| # 64 - 116 (reserved) |
| 00 00 00 00 00 00 00 00 |
| 00 00 00 00 00 00 00 00 |
| 00 00 00 00 00 00 00 00 |
| 00 00 00 00 00 00 00 00 |
| 00 00 00 00 00 00 00 00 |
| 00 00 00 00 00 00 00 00 |
| 00 00 00 00 00 |
| |
| # 117 - 118 Module ID: Module Manufacturers JEDEC ID Code |
| # 0x80AD = Hynix |
| 80 AD |
| |
| # 119 Module ID: Module Manufacturing Location - oem specified |
| # 120 Module ID: Module Manufacture Year in BCD |
| # 0x00 = 2000 |
| 00 00 |
| |
| # 121 Module ID: Module Manufacture week |
| # 0x00 = 0th week |
| 00 |
| |
| # 122 - 125: Module Serial Number |
| 00 00 00 00 |
| |
| # 126 - 127: Cyclical Redundancy Code |
| E9 40 |