| /* SPDX-License-Identifier: GPL-2.0-or-later */ |
| |
| #include <console/console.h> |
| #include <device/device.h> |
| #include <device/pnp.h> |
| #include "fintek_internal.h" |
| #include "f81866d.h" |
| |
| #define LDN_REG 0x07 |
| #define PORT_SELECT_REGISTER 0x27 |
| #define MULTI_FUNC_SEL3_REG 0x29 |
| #define IRQ_SHARE_REGISTER 0xF0 |
| #define FIFO_SEL_MODE 0xF6 |
| |
| /* |
| * f81866d_uart_init enables all necessary registers for UART 3/4 |
| * Fintek needs to know if pins are used as GPIO or UART pins |
| * Share interrupt usage needs to be enabled |
| */ |
| void f81866d_uart_init(struct device *dev) |
| { |
| struct resource *res = find_resource(dev, PNP_IDX_IO0); |
| u8 tmp; |
| |
| if (!res) { |
| printk(BIOS_WARNING, "%s: No UART resource found.\n", __func__); |
| return; |
| } |
| |
| pnp_enter_conf_mode(dev); |
| |
| // Set Port Select Register (Bit 0) = 0 |
| // before accessing Multi Function Select 3 Register |
| tmp = pnp_read_config(dev, PORT_SELECT_REGISTER); |
| pnp_write_config(dev, PORT_SELECT_REGISTER, tmp & 0xFE); |
| |
| // Set UART 3 function (Bit 4/5), otherwise pin 36-43 are GPIO |
| if (dev->path.pnp.device == F81866D_SP3) { |
| tmp = pnp_read_config(dev, MULTI_FUNC_SEL3_REG); |
| pnp_write_config(dev, MULTI_FUNC_SEL3_REG, tmp | 0x30); |
| } |
| |
| // Set UART 4 function (Bit 6/7), otherwise pin 44-51 are GPIO |
| if (dev->path.pnp.device == F81866D_SP4) { |
| tmp = pnp_read_config(dev, MULTI_FUNC_SEL3_REG); |
| pnp_write_config(dev, MULTI_FUNC_SEL3_REG, tmp | 0xC0); |
| } |
| |
| // Select UART X in LDN register |
| pnp_write_config(dev, LDN_REG, dev->path.pnp.device & 0xff); |
| // Set IRQ trigger mode from active low to high (Bit 3) |
| tmp = pnp_read_config(dev, FIFO_SEL_MODE); |
| pnp_write_config(dev, FIFO_SEL_MODE, tmp | 0x8); |
| // Enable share interrupt (Bit 0) |
| pnp_write_config(dev, IRQ_SHARE_REGISTER, 0x01); |
| |
| pnp_exit_conf_mode(dev); |
| } |