| /* SPDX-License-Identifier: GPL-2.0-only */ |
| |
| #include <device/mmio.h> |
| #include <console/console.h> |
| #include <soc/wdt.h> |
| #include <vendorcode/google/chromeos/chromeos.h> |
| |
| int mtk_wdt_init(void) |
| { |
| uint32_t wdt_sta; |
| |
| /* Write Mode register will clear status register */ |
| wdt_sta = read32(&mtk_wdt->wdt_status); |
| |
| printk(BIOS_INFO, "WDT: Last reset was "); |
| if (wdt_sta & MTK_WDT_STA_HW_RST) { |
| printk(BIOS_INFO, "hardware watchdog\n"); |
| mark_watchdog_tombstone(); |
| } else if (wdt_sta & MTK_WDT_STA_SW_RST) |
| printk(BIOS_INFO, "normal software reboot\n"); |
| else if (wdt_sta & MTK_WDT_STA_SPM_RST) |
| printk(BIOS_INFO, "SPM reboot\n"); |
| else if (!wdt_sta) |
| printk(BIOS_INFO, "cold boot\n"); |
| else |
| printk(BIOS_INFO, "unexpected reset type: %#.8x\n", wdt_sta); |
| |
| /* Config watchdog reboot mode: |
| * Clearing bits: |
| * DUAL_MODE & IRQ: trigger reset instead of irq then reset. |
| * EXT_POL: select watchdog output signal as active low. |
| * ENABLE: disable watchdog on initialization. |
| * Setting bit EXTEN to enable watchdog output. |
| */ |
| clrsetbits32(&mtk_wdt->wdt_mode, |
| MTK_WDT_MODE_DUAL_MODE | MTK_WDT_MODE_IRQ | |
| MTK_WDT_MODE_EXT_POL | MTK_WDT_MODE_ENABLE, |
| MTK_WDT_MODE_EXTEN | MTK_WDT_MODE_KEY); |
| |
| return wdt_sta; |
| } |