| /* SPDX-License-Identifier: GPL-2.0-only */ |
| |
| #ifndef _SOC_CHIP_H_ |
| #define _SOC_CHIP_H_ |
| |
| #include <stdint.h> |
| #include <fsp/util.h> |
| #include <soc/pci_devs.h> |
| #include <soc/pm.h> |
| |
| /// |
| /// MRC Flags bits |
| /// |
| #define MRC_FLAG_ECC_EN BIT0 |
| #define MRC_FLAG_SCRAMBLE_EN BIT1 |
| #define MRC_FLAG_MEMTEST_EN BIT2 |
| |
| /* 0b DDR "fly-by" topology else 1b DDR "tree" topology */ |
| #define MRC_FLAG_TOP_TREE_EN BIT3 |
| |
| /* If set ODR signal is asserted to DRAM devices on writes */ |
| #define MRC_FLAG_WR_ODT_EN BIT4 |
| |
| struct soc_intel_quark_config { |
| /* |
| * MemoryInit: |
| * |
| * The following fields come from FspUpdVpd.h and are defined as PCDs |
| * for the FSP binary. Data for these fields comes from the board's |
| * devicetree.cb file which gets processed into static.c and then |
| * built into the coreboot image. The fields below contain retain |
| * the FSP PCD field name. |
| */ |
| |
| uint32_t FspReservedMemoryLength; /* FSP reserved memory in bytes */ |
| |
| uint32_t Flags; /* Bitmap of MRC_FLAG_XXX defs above */ |
| uint32_t tRAS; /* ACT to PRE command period in picoseconds */ |
| |
| /* Delay from start of internal write transaction to internal read |
| * command in picoseconds |
| */ |
| uint32_t tWTR; |
| |
| /* ACT to ACT command period (JESD79 specific to page size 1K/2K) in |
| * picoseconds |
| */ |
| uint32_t tRRD; |
| |
| /* Four activate window (JESD79 specific to page size 1K/2K) in |
| * picoseconds |
| */ |
| uint32_t tFAW; |
| uint8_t DramWidth; /* 0=x8, 1=x16, others=RESERVED */ |
| |
| /* 0=DDRFREQ_800, 1=DDRFREQ_1066, others=RESERVED. Only 533MHz SKU |
| * support 1066 memory |
| */ |
| uint8_t DramSpeed; |
| uint8_t DramType; /* 0=DDR3,1=DDR3L, others=RESERVED */ |
| |
| /* bit[0] RANK0_EN, bit[1] RANK1_EN, others=RESERVED */ |
| uint8_t RankMask; |
| uint8_t ChanMask; /* bit[0] CHAN0_EN, others=RESERVED */ |
| uint8_t ChanWidth; /* 1=x16, others=RESERVED */ |
| |
| /* 0, 1, 2 (mode 2 forced if ecc enabled), others=RESERVED */ |
| uint8_t AddrMode; |
| |
| /* 1=1.95us, 2=3.9us, 3=7.8us, others=RESERVED. REFRESH_RATE */ |
| uint8_t SrInt; |
| uint8_t SrTemp; /* 0=normal, 1=extended, others=RESERVED */ |
| |
| /* 0=34ohm, 1=40ohm, others=RESERVED. RON_VALUE Select MRS1.DIC driver |
| * impedance control. |
| */ |
| uint8_t DramRonVal; |
| uint8_t DramRttNomVal; /* 0=40ohm, 1=60ohm, 2=120ohm, others=RSVD */ |
| uint8_t DramRttWrVal; /* 0=off others=RESERVED */ |
| |
| /* 0=off, 1=60ohm, 2=120ohm, 3=180ohm, others=RESERVED */ |
| uint8_t SocRdOdtVal; |
| uint8_t SocWrRonVal; /* 0=27ohm, 1=32ohm, 2=40ohm, others=RESERVED */ |
| uint8_t SocWrSlewRate; /* 0=2.5V/ns, 1=4V/ns, others=RESERVED */ |
| |
| /* 0=512Mb, 1=1Gb, 2=2Gb, 3=4Gb, others=RESERVED */ |
| uint8_t DramDensity; |
| uint8_t tCL; /* DRAM CAS Latency in clocks */ |
| |
| /* ECC scrub interval in miliseconds 1..255 (0 works as feature |
| * disable) |
| */ |
| uint8_t EccScrubInterval; |
| |
| /* Number of 32B blocks read for ECC scrub 2..16 */ |
| uint8_t EccScrubBlkSize; |
| |
| uint8_t SmmTsegSize; /* SMM size in MiB */ |
| }; |
| |
| #endif |