| # the IBM E325 |
| # This will make a target directory of ./e325 |
| |
| loadoptions |
| |
| target e325 |
| |
| uses ARCH |
| uses CONFIG_COMPRESS |
| uses CONFIG_IOAPIC |
| uses CONFIG_ROM_STREAM |
| uses CONFIG_ROM_STREAM_START |
| uses CONFIG_UDELAY_TSC |
| uses CPU_FIXUP |
| uses FALLBACK_SIZE |
| uses HAVE_FALLBACK_BOOT |
| uses HAVE_MP_TABLE |
| uses HAVE_PIRQ_TABLE |
| uses HAVE_HARD_RESET |
| uses i586 |
| uses i686 |
| uses INTEL_PPRO_MTRR |
| uses HEAP_SIZE |
| uses IRQ_SLOT_COUNT |
| uses k7 |
| uses k8 |
| uses MAINBOARD_PART_NUMBER |
| uses MAINBOARD_VENDOR |
| uses CONFIG_SMP |
| uses CONFIG_MAX_CPUS |
| uses MEMORY_HOLE |
| uses PAYLOAD_SIZE |
| uses _RAMBASE |
| uses _ROMBASE |
| uses ROM_IMAGE_SIZE |
| uses ROM_SECTION_OFFSET |
| uses ROM_SECTION_SIZE |
| uses ROM_SIZE |
| uses STACK_SIZE |
| uses USE_FALLBACK_IMAGE |
| uses USE_OPTION_TABLE |
| uses HAVE_OPTION_TABLE |
| uses MAXIMUM_CONSOLE_LOGLEVEL |
| uses DEFAULT_CONSOLE_LOGLEVEL |
| uses CONFIG_CONSOLE_SERIAL8250 |
| uses MAINBOARD |
| uses CONFIG_CHIP_CONFIGURE |
| uses XIP_ROM_SIZE |
| uses XIP_ROM_BASE |
| uses LINUXBIOS_EXTRA_VERSION |
| |
| option CONFIG_CHIP_CONFIGURE=1 |
| |
| option MAXIMUM_CONSOLE_LOGLEVEL=8 |
| option DEFAULT_CONSOLE_LOGLEVEL=8 |
| option CONFIG_CONSOLE_SERIAL8250=1 |
| |
| option CPU_FIXUP=1 |
| option CONFIG_UDELAY_TSC=0 |
| option i686=1 |
| option i586=1 |
| option INTEL_PPRO_MTRR=1 |
| option k7=1 |
| option k8=1 |
| |
| option ROM_SIZE=1048576 |
| |
| |
| option HAVE_OPTION_TABLE=1 |
| option CONFIG_ROM_STREAM=1 |
| option HAVE_FALLBACK_BOOT=1 |
| |
| ### |
| ### Compute the location and size of where this firmware image |
| ### (linuxBIOS plus bootloader) will live in the boot rom chip. |
| ### |
| option FALLBACK_SIZE=131072 |
| |
| ## LinuxBIOS C code runs at this location in RAM |
| option _RAMBASE=0x00004000 |
| |
| # |
| ### |
| ### Compute the start location and size size of |
| ### The linuxBIOS bootloader. |
| ### |
| |
| # |
| # Arima hdama |
| romimage "normal" |
| option USE_FALLBACK_IMAGE=0 |
| option ROM_IMAGE_SIZE=0x10000 |
| option LINUXBIOS_EXTRA_VERSION=".0Normal" |
| mainboard ibm/e325 |
| payload //etc/hosts |
| end |
| |
| romimage "fallback" |
| option USE_FALLBACK_IMAGE=1 |
| option ROM_IMAGE_SIZE=0x10000 |
| option LINUXBIOS_EXTRA_VERSION=".0Fallback" |
| mainboard ibm/e325 |
| payload //etc/hosts |
| # use this to test a build if you don't have the etherboot |
| # payload /etc/hosts |
| end |
| |
| buildrom ./linuxbios.rom ROM_SIZE "normal" "fallback" |