| chip northbridge/intel/sandybridge |
| register "gpu_dp_b_hotplug" = "4" |
| register "gpu_dp_c_hotplug" = "4" |
| # BTX mainboard: Reversed mapping |
| register "spd_addresses" = "{0, 0x52, 0, 0x50}" |
| device domain 0x0 on |
| chip southbridge/intel/bd82x6x # Intel Series 6 Cougar Point PCH |
| register "docking_supported" = "0" |
| register "gen1_dec" = "0x00fc0a01" |
| register "gen2_dec" = "0x00fc0801" |
| register "pcie_hotplug_map" = "{ 0, 0, 0, 0, 0, 0, 0, 0 }" |
| register "pcie_port_coalesce" = "1" |
| register "sata_interface_speed_support" = "0x3" |
| register "sata_port_map" = "0x7" # 0x1: 2.5" slot |
| # 0x2: DVD |
| # 0x4: mSATA |
| register "spi_lvscc" = "0x2005" |
| register "spi_uvscc" = "0x2005" |
| register "superspeed_capable_ports" = "0x0000000f" |
| register "xhci_overcurrent_mapping" = "0x00000c03" |
| register "xhci_switchable_ports" = "0x0000000f" |
| device ref xhci on # USB 3.0 Controller |
| subsystemid 0x103c 0x3398 |
| end |
| device ref mei1 off # Management Engine Interface 1 |
| end |
| device ref gbe on # Intel Gigabit Ethernet |
| subsystemid 0x103c 0x3398 |
| end |
| device ref ehci2 on # USB2 EHCI #2 |
| subsystemid 0x103c 0x3398 |
| end |
| device ref hda on # High Definition Audio |
| subsystemid 0x103c 0x3398 |
| end |
| device ref pcie_rp1 on # Mini-PCIe WLAN |
| end |
| device ref ehci1 on # USB2 EHCI #1 |
| subsystemid 0x103c 0x3398 |
| end |
| device ref pci_bridge on # PCI bridge |
| subsystemid 0x103c 0x3398 |
| end |
| device ref lpc on # LPC bridge |
| chip superio/common # Super I/O grabbed from 8200SFF devicetree |
| device pnp 2e.ff on # passes SIO base addr to SSDT gen |
| chip superio/nuvoton/npcd378 |
| device pnp 2e.0 off end # Floppy |
| device pnp 2e.1 off end # Parallel |
| device pnp 2e.2 off # COM1 |
| io 0x60 = 0x2f8 |
| irq 0x70 = 3 |
| end |
| device pnp 2e.3 on # COM2, IR |
| io 0x60 = 0x3f8 |
| irq 0x70 = 4 |
| end |
| device pnp 2e.4 on # LED control |
| io 0x60 = 0x600 |
| # IOBASE[0h] = bit0 LED red / green |
| # IOBASE[0h] = bit1-4 LED PWM duty cycle |
| # IOBASE[1h] = bit6 SWCC |
| |
| io 0x62 = 0x610 |
| # IOBASE [0h] = GPES |
| # IOBASE [1h] = GPEE |
| # IOBASE [4h:7h] = 32bit upcounter at 1Mhz |
| # IOBASE [8h:bh] = GPS |
| # IOBASE [ch:fh] = GPE |
| end |
| device pnp 2e.5 on # Mouse |
| irq 0x70 = 0xc |
| end |
| device pnp 2e.6 on # Keyboard |
| io 0x60 = 0x0060 |
| io 0x62 = 0x0064 |
| irq 0x70 = 0x01 |
| # serialice: Vendor writes: |
| drq 0xf0 = 0x40 |
| end |
| device pnp 2e.7 on # WDT ? |
| io 0x60 = 0x620 |
| end |
| device pnp 2e.8 on # HWM |
| io 0x60 = 0x800 |
| # IOBASE[0h:feh] HWM page |
| # IOBASE[ffh] bit0-bit3 page selector |
| |
| drq 0xf0 = 0x20 |
| drq 0xf1 = 0x01 |
| drq 0xf2 = 0x40 |
| drq 0xf3 = 0x01 |
| |
| drq 0xf4 = 0x66 |
| drq 0xf5 = 0x67 |
| drq 0xf6 = 0x66 |
| drq 0xf7 = 0x01 |
| end |
| device pnp 2e.f on # GPIO OD ? |
| drq 0xf1 = 0x97 |
| drq 0xf2 = 0x01 |
| drq 0xf5 = 0x08 |
| drq 0xfe = 0x80 |
| end |
| device pnp 2e.15 on # BUS ? |
| io 0x60 = 0x0680 |
| io 0x62 = 0x0690 |
| end |
| device pnp 2e.1c on # Suspend Control ? |
| io 0x60 = 0x640 |
| # writing to IOBASE[5h] |
| # 0x0: Power off |
| # 0x9: Power off and bricked until CMOS battery removed |
| end |
| device pnp 2e.1e on # GPIO ? |
| io 0x60 = 0x660 |
| drq 0xf4 = 0x01 |
| # skip the following, as it |
| # looks like remapped registers |
| #drq 0xf5 = 0x06 |
| #drq 0xf6 = 0x60 |
| #drq 0xfe = 0x03 |
| end |
| end |
| end |
| end |
| chip drivers/pc80/tpm |
| device pnp 4e.0 on end # TPM module |
| end |
| end |
| device ref sata1 on # SATA Controller 1 |
| subsystemid 0x103c 0x3398 |
| end |
| device ref smbus on # SMBus |
| subsystemid 0x103c 0x3398 |
| end |
| end |
| device ref host_bridge on # Host bridge Host bridge |
| subsystemid 0x103c 0x3398 |
| end |
| device ref peg10 on end # PEG |
| device ref igd on # iGPU |
| subsystemid 0x103c 0x3398 |
| end |
| end |
| end |