| /* SPDX-License-Identifier: GPL-2.0-only */ |
| |
| #include <console/console.h> |
| #include <delay.h> |
| #include <device/i2c_simple.h> |
| #include <reset.h> |
| #include <stdint.h> |
| |
| #include "pmic.h" |
| |
| enum { |
| MAX77620_I2C_ADDR = 0x3c |
| }; |
| |
| struct max77620_init_reg { |
| u8 reg; |
| u8 val; |
| u8 delay; |
| }; |
| |
| static void pmic_write_reg(unsigned int bus, uint8_t reg, uint8_t val, int delay) |
| { |
| if (i2c_writeb(bus, MAX77620_I2C_ADDR, reg, val)) { |
| printk(BIOS_ERR, "%s: reg = 0x%02X, value = 0x%02X failed!\n", |
| __func__, reg, val); |
| /* Reset the board on any PMIC write error */ |
| board_reset(); |
| } else { |
| if (delay) |
| udelay(500); |
| } |
| } |
| |
| void pmic_init(unsigned int bus) |
| { |
| /* Setup/Enable GPIO5 - VDD_CPU_REG_EN */ |
| pmic_write_reg(bus, MAX77620_GPIO5_REG, 0x09, 1); |
| |
| /* Setup/Enable GPIO1 - VDD_HDMI_5V0_BST_EN -- ??? */ |
| pmic_write_reg(bus, MAX77620_GPIO1_REG, 0x09, 1); |
| |
| /* GPIO 0,1,5,6,7 = GPIO, 2,3,4 = alt mode */ |
| pmic_write_reg(bus, MAX77620_AME_GPIO, 0x1c, 1); |
| |
| /* Disable SD1 Remote Sense, Set SD1 for LPDDR4 to 1.125v? */ |
| pmic_write_reg(bus, MAX77620_CNFG2SD_REG, 0x04, 1); |
| |
| pmic_write_reg(bus, MAX77620_SD1_REG, 0x2a, 1); |
| |
| /* CNFG1_L2 = 0xF2 for 3.3v, enabled */ |
| pmic_write_reg(bus, MAX77620_CNFG1_L2_REG, 0xf2, 1); |
| |
| /* CNFG1_L1 = 0xCA for 1.05v, enabled */ |
| pmic_write_reg(bus, MAX77620_CNFG1_L1_REG, 0xca, 1); |
| |
| printk(BIOS_DEBUG, "PMIC init done\n"); |
| } |