| # SPDX-License-Identifier: GPL-2.0-only |
| |
| chip soc/amd/picasso |
| # ACP Configuration |
| register "common_config.acp_config.acp_pin_cfg" = "I2S_PINS_I2S_TDM" |
| |
| # Set FADT Configuration |
| register "common_config.fadt_boot_arch" = "ACPI_FADT_LEGACY_DEVICES | ACPI_FADT_8042" |
| register "common_config.fadt_flags" = "ACPI_FADT_SLEEP_BUTTON" # See table 5-34 ACPI 6.3 spec |
| |
| register "has_usb2_phy_tune_params" = "1" |
| |
| # Controller0 Port0 Default |
| register "usb_2_port_tune_params[0]" = "{ |
| .com_pds_tune = 0x03, |
| .sq_rx_tune = 0x3, |
| .tx_fsls_tune = 0x3, |
| .tx_pre_emp_amp_tune = 0x03, |
| .tx_pre_emp_pulse_tune = 0x0, |
| .tx_rise_tune = 0x1, |
| .tx_vref_tune = 0x6, |
| .tx_hsxv_tune = 0x3, |
| .tx_res_tune = 0x01, |
| }" |
| |
| # Controller0 Port1 Default |
| register "usb_2_port_tune_params[1]" = "{ |
| .com_pds_tune = 0x03, |
| .sq_rx_tune = 0x3, |
| .tx_fsls_tune = 0x3, |
| .tx_pre_emp_amp_tune = 0x03, |
| .tx_pre_emp_pulse_tune = 0x0, |
| .tx_rise_tune = 0x1, |
| .tx_vref_tune = 0x6, |
| .tx_hsxv_tune = 0x3, |
| .tx_res_tune = 0x01, |
| }" |
| |
| # Controller0 Port2 Default |
| register "usb_2_port_tune_params[2]" = "{ |
| .com_pds_tune = 0x03, |
| .sq_rx_tune = 0x3, |
| .tx_fsls_tune = 0x3, |
| .tx_pre_emp_amp_tune = 0x03, |
| .tx_pre_emp_pulse_tune = 0x0, |
| .tx_rise_tune = 0x1, |
| .tx_vref_tune = 0x6, |
| .tx_hsxv_tune = 0x3, |
| .tx_res_tune = 0x01, |
| }" |
| |
| # Controller0 Port3 Default |
| register "usb_2_port_tune_params[3]" = "{ |
| .com_pds_tune = 0x03, |
| .sq_rx_tune = 0x3, |
| .tx_fsls_tune = 0x3, |
| .tx_pre_emp_amp_tune = 0x03, |
| .tx_pre_emp_pulse_tune = 0x0, |
| .tx_rise_tune = 0x1, |
| .tx_vref_tune = 0x6, |
| .tx_hsxv_tune = 0x3, |
| .tx_res_tune = 0x01, |
| }" |
| |
| # Controller0 Port4 Default |
| register "usb_2_port_tune_params[4]" = "{ |
| .com_pds_tune = 0x03, |
| .sq_rx_tune = 0x3, |
| .tx_fsls_tune = 0x3, |
| .tx_pre_emp_amp_tune = 0x02, |
| .tx_pre_emp_pulse_tune = 0x0, |
| .tx_rise_tune = 0x1, |
| .tx_vref_tune = 0x5, |
| .tx_hsxv_tune = 0x3, |
| .tx_res_tune = 0x01, |
| }" |
| |
| # Controller0 Port5 Default |
| register "usb_2_port_tune_params[5]" = "{ |
| .com_pds_tune = 0x03, |
| .sq_rx_tune = 0x3, |
| .tx_fsls_tune = 0x3, |
| .tx_pre_emp_amp_tune = 0x02, |
| .tx_pre_emp_pulse_tune = 0x0, |
| .tx_rise_tune = 0x1, |
| .tx_vref_tune = 0x5, |
| .tx_hsxv_tune = 0x3, |
| .tx_res_tune = 0x01, |
| }" |
| |
| register "usb_pd_config_override[0]" = "{ |
| .rfmux_override_en = 1, |
| .rfmux_config = USB_PD_RFMUX_DP_X4_MODE, |
| }" |
| register "usb_pd_config_override[1]" = "{ |
| .rfmux_override_en = 1, |
| .rfmux_config = USB_PD_RFMUX_DP_X4_MODE, |
| }" |
| |
| # USB OC pin mapping; all ports share one OC pin |
| register "usb_port_overcurrent_pin[0]" = "USB_OC_PIN_0" |
| register "usb_port_overcurrent_pin[1]" = "USB_OC_PIN_0" |
| register "usb_port_overcurrent_pin[2]" = "USB_OC_PIN_0" |
| register "usb_port_overcurrent_pin[3]" = "USB_OC_PIN_0" |
| register "usb_port_overcurrent_pin[4]" = "USB_OC_PIN_0" |
| register "usb_port_overcurrent_pin[5]" = "USB_OC_PIN_0" |
| |
| # eSPI Configuration |
| register "common_config.espi_config" = "{ |
| .std_io_decode_bitmap = ESPI_DECODE_IO_0X60_0X64_EN, |
| .generic_io_range[0] = { |
| .base = 0x662, |
| .size = 8, |
| }, |
| |
| .io_mode = ESPI_IO_MODE_SINGLE, |
| .op_freq_mhz = ESPI_OP_FREQ_33_MHZ, |
| .crc_check_enable = 1, |
| .alert_pin = ESPI_ALERT_PIN_PUSH_PULL, |
| .periph_ch_en = 0, |
| .vw_ch_en = 0, |
| .oob_ch_en = 0, |
| .flash_ch_en = 0, |
| }" |
| |
| # general purpose PCIe clock output configuration |
| register "gpp_clk_config[0]" = "GPP_CLK_OFF" |
| register "gpp_clk_config[1]" = "GPP_CLK_OFF" |
| register "gpp_clk_config[2]" = "GPP_CLK_REQ" |
| register "gpp_clk_config[3]" = "GPP_CLK_ON" |
| register "gpp_clk_config[4]" = "GPP_CLK_ON" |
| register "gpp_clk_config[5]" = "GPP_CLK_OFF" |
| register "gpp_clk_config[6]" = "GPP_CLK_OFF" |
| |
| register "pspp_policy" = "DXIO_PSPP_BALANCED" |
| |
| device domain 0 on |
| subsystemid 0x1022 0x1510 inherit |
| device ref iommu on end |
| device ref gpp_bridge_0 on end |
| device ref gpp_bridge_1 on end |
| device ref gpp_bridge_4 on end # NVMe |
| device ref internal_bridge_a on |
| device ref gfx on end # Internal GPU |
| device ref gfx_hda on end # Display HDA |
| device ref crypto on end # Crypto Coprocessor |
| device ref xhci_0 on end # USB 3.1 |
| device ref xhci_1 off end # USB 3.1 |
| device ref acp on end # Audio |
| device ref hda on end # HDA |
| device ref mp2 on end # non-Sensor Fusion Hub device |
| end |
| device ref internal_bridge_b on |
| device ref sata off end # AHCI |
| device ref xgbe_0 off end # integrated Ethernet MAC |
| device ref xgbe_1 off end # integrated Ethernet MAC |
| end |
| device ref lpc_bridge on |
| # chip superio/smsc/sio1036 # optional debug card |
| end |
| end # domain |
| |
| device ref uart_0 on end # console |
| device ref uart_1 on end |
| |
| end # chip soc/amd/picasso |