| chip soc/intel/alderlake |
| register "power_limits_config[RPL_P_682_482_282_28W_CORE]" = "{ |
| .tdp_pl1_override = 20, |
| .tdp_pl2_override = 56, |
| }" |
| |
| device domain 0 on |
| subsystemid 0x1558 0x51b1 inherit |
| |
| device ref pcie4_0 on |
| # CPU RP#1 x4, Clock 0 (SSD2) |
| register "cpu_pcie_rp[CPU_RP(1)]" = "{ |
| .clk_src = 0, |
| .clk_req = 0, |
| .flags = PCIE_RP_LTR | PCIE_RP_AER, |
| }" |
| chip soc/intel/common/block/pcie/rtd3 |
| register "reset_gpio" = "ACPI_GPIO_OUTPUT_ACTIVE_LOW(GPP_F20)" # M2_SSD2_RST# |
| register "srcclk_pin" = "0" # SSD2_CLKREQ# |
| device generic 0 on end |
| end |
| end |
| device ref pcie4_1 on |
| # CPU RP#3 x4, Clock 4 (SSD1) |
| register "cpu_pcie_rp[CPU_RP(3)]" = "{ |
| .clk_src = 4, |
| .clk_req = 4, |
| .flags = PCIE_RP_LTR | PCIE_RP_AER, |
| }" |
| chip soc/intel/common/block/pcie/rtd3 |
| register "reset_gpio" = "ACPI_GPIO_OUTPUT_ACTIVE_LOW(GPP_B16)" # M2_SSD1_RST# |
| register "srcclk_pin" = "4" # SSD1_CLKREQ# |
| device generic 0 on end |
| end |
| end |
| device ref tbt_pcie_rp0 on end |
| device ref tcss_xhci on |
| register "tcss_ports[0]" = "TCSS_PORT_DEFAULT(OC_SKIP)" |
| end |
| device ref tcss_dma0 on end |
| device ref xhci on |
| register "usb2_ports" = "{ |
| [0] = USB2_PORT_MID(OC_SKIP), /* Type-A */ |
| [1] = USB2_PORT_MID(OC_SKIP), /* Type-A */ |
| [2] = USB2_PORT_TYPE_C(OC_SKIP), /* J_TYPEC1 (USB-C) */ |
| [4] = USB2_PORT_MID(OC_SKIP), /* Fingerprint */ |
| [5] = USB2_PORT_TYPE_C(OC_SKIP), /* J_TYPEC2 (Thunderbolt) */ |
| [6] = USB2_PORT_MID(OC_SKIP), /* Camera */ |
| [9] = USB2_PORT_MID(OC_SKIP), /* Bluetooth */ |
| }" |
| register "usb3_ports" = "{ |
| [0] = USB3_PORT_DEFAULT(OC_SKIP), /* Type-A */ |
| [1] = USB3_PORT_DEFAULT(OC_SKIP), /* J_TYPEC1 CH0 */ |
| [2] = USB3_PORT_DEFAULT(OC_SKIP), /* J_TYPEC1 CH1 */ |
| }" |
| end |
| device ref i2c0 on |
| # Touchpad I2C bus |
| register "serial_io_i2c_mode[PchSerialIoIndexI2C0]" = "PchSerialIoPci" |
| chip drivers/i2c/hid |
| register "generic.hid" = ""ELAN0412"" |
| register "generic.desc" = ""ELAN Touchpad"" |
| register "generic.irq_gpio" = "ACPI_GPIO_IRQ_LEVEL_LOW(GPP_E12)" |
| register "generic.detect" = "1" |
| register "hid_desc_reg_offset" = "0x01" |
| device i2c 15 on end |
| end |
| chip drivers/i2c/hid |
| register "generic.hid" = ""FTCS1000"" |
| register "generic.desc" = ""FocalTech Touchpad"" |
| register "generic.irq_gpio" = "ACPI_GPIO_IRQ_LEVEL_LOW(GPP_E12)" |
| register "generic.detect" = "1" |
| register "hid_desc_reg_offset" = "0x01" |
| device i2c 38 on end |
| end |
| end |
| device ref sata off end |
| device ref pcie_rp5 on |
| # PCIe RP#5 x1, Clock 2 (WLAN) |
| register "pch_pcie_rp[PCH_RP(5)]" = "{ |
| .clk_src = 2, |
| .clk_req = 2, |
| .flags = PCIE_RP_LTR | PCIE_RP_AER, |
| }" |
| end |
| device ref pcie_rp6 on |
| # PCIe RP#6 x1, Clock 5 (CARD) |
| register "pch_pcie_rp[PCH_RP(6)]" = "{ |
| .clk_src = 5, |
| .clk_req = 5, |
| .flags = PCIE_RP_HOTPLUG | PCIE_RP_LTR | PCIE_RP_AER, |
| }" |
| end |
| device ref pcie_rp8 on |
| # PCIe RP#8 x1, Clock 6 (GLAN) |
| register "pch_pcie_rp[PCH_RP(8)]" = "{ |
| .clk_src = 6, |
| .clk_req = 6, |
| .flags = PCIE_RP_LTR | PCIE_RP_AER, |
| }" |
| end |
| end |
| end |