| /* |
| * This file is part of the coreboot project. |
| * |
| * Copyright (C) 2015 Damien Zammit <damien@zamaudio.com> |
| * Copyright (C) 2017 Arthur Heymans <arthur@aheymans.xyz> |
| * |
| * This program is free software; you can redistribute it and/or modify |
| * it under the terms of the GNU General Public License as published by |
| * the Free Software Foundation; either version 2 of the License, or |
| * (at your option) any later version. |
| * |
| * This program is distributed in the hope that it will be useful, |
| * but WITHOUT ANY WARRANTY; without even the implied warranty of |
| * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the |
| * GNU General Public License for more details. |
| */ |
| |
| #include <device/pnp_ops.h> |
| #include <device/pci_ops.h> |
| #include <console/console.h> |
| #include <cpu/intel/romstage.h> |
| #include <cpu/x86/bist.h> |
| #include <northbridge/intel/x4x/iomap.h> |
| #include <northbridge/intel/x4x/x4x.h> |
| #include <southbridge/intel/common/gpio.h> |
| #include <southbridge/intel/i82801gx/i82801gx.h> |
| #include <superio/nuvoton/common/nuvoton.h> |
| #include <superio/nuvoton/nct6776/nct6776.h> |
| #include <superio/winbond/common/winbond.h> |
| #include <superio/winbond/w83627dhg/w83627dhg.h> |
| |
| #define SERIAL_DEV_R2 PNP_DEV(0x2e, NCT6776_SP1) |
| #define SERIAL_DEV_R1 PNP_DEV(0x2e, W83627DHG_SP1) |
| #define SUPERIO_DEV PNP_DEV(0x2e, 0) |
| #define LPC_DEV PCI_DEV(0, 0x1f, 0) |
| |
| static void mb_lpc_setup(void) |
| { |
| u32 reg32; |
| /* Set the value for GPIO base address register and enable GPIO. */ |
| pci_write_config32(LPC_DEV, GPIO_BASE, (DEFAULT_GPIOBASE | 1)); |
| pci_write_config8(LPC_DEV, GPIO_CNTL, 0x10); |
| |
| setup_pch_gpios(&mainboard_gpio_map); |
| |
| /* Set GPIOs on superio, enable UART */ |
| if (IS_ENABLED(CONFIG_SUPERIO_NUVOTON_NCT6776)) { |
| nuvoton_pnp_enter_conf_state(SERIAL_DEV_R2); |
| pnp_set_logical_device(SERIAL_DEV_R2); |
| |
| pnp_write_config(SERIAL_DEV_R2, 0x1c, 0x80); |
| pnp_write_config(SERIAL_DEV_R2, 0x27, 0x80); |
| pnp_write_config(SERIAL_DEV_R2, 0x2a, 0x60); |
| |
| nuvoton_pnp_exit_conf_state(SERIAL_DEV_R2); |
| nuvoton_enable_serial(SERIAL_DEV_R2, CONFIG_TTYS0_BASE); |
| } else { |
| winbond_enable_serial(SERIAL_DEV_R1, CONFIG_TTYS0_BASE); |
| } |
| /* IRQ routing */ |
| RCBA16(D31IR) = 0x0132; |
| RCBA16(D29IR) = 0x0237; |
| |
| /* Enable IOAPIC */ |
| RCBA8(OIC) = 0x03; |
| RCBA8(OIC); |
| |
| reg32 = RCBA32(GCS); |
| reg32 |= (1 << 5); |
| RCBA32(GCS) = reg32; |
| |
| RCBA32(CG) = 0x00000001; |
| } |
| |
| static void ich7_enable_lpc(void) |
| { |
| pci_write_config8(PCI_DEV(0, 0x1f, 0), SERIRQ_CNTL, 0xd0); |
| /* Decode range */ |
| pci_write_config16(PCI_DEV(0, 0x1f, 0), LPC_EN, CNF1_LPC_EN |
| | KBC_LPC_EN | LPT_LPC_EN | COMA_LPC_EN); |
| pci_write_config32(PCI_DEV(0, 0x1f, 0), GEN1_DEC, 0x000c0291); |
| } |
| |
| void mainboard_romstage_entry(unsigned long bist) |
| { |
| // ch0 ch1 |
| const u8 spd_addrmap[4] = { 0x50, 0, 0x52, 0 }; |
| u8 boot_path = 0; |
| u8 s3_resume; |
| |
| /* Set southbridge and Super I/O GPIOs. */ |
| ich7_enable_lpc(); |
| mb_lpc_setup(); |
| |
| console_init(); |
| |
| report_bist_failure(bist); |
| enable_smbus(); |
| |
| x4x_early_init(); |
| |
| s3_resume = southbridge_detect_s3_resume(); |
| if (s3_resume) |
| boot_path = BOOT_PATH_RESUME; |
| if (MCHBAR32(PMSTS_MCHBAR) & PMSTS_WARM_RESET) |
| boot_path = BOOT_PATH_WARM_RESET; |
| |
| sdram_initialize(boot_path, spd_addrmap); |
| |
| x4x_late_init(s3_resume); |
| |
| printk(BIOS_DEBUG, "x4x late init complete\n"); |
| |
| } |