| /* SPDX-License-Identifier: GPL-2.0-only */ |
| |
| #include <bootstate.h> |
| #include <console/console.h> |
| #include <device/i2c_simple.h> |
| #include <soc/ramstage.h> |
| #include <variant/gpio.h> |
| |
| void mainboard_silicon_init_params(FSP_SIL_UPD *params) |
| { |
| /* Configure pads prior to SiliconInit() in case there's any |
| * dependencies during hardware initialization. */ |
| gpio_configure_pads(gpio_table, ARRAY_SIZE(gpio_table)); |
| params->CdClock = 3; |
| } |
| |
| static void ioexpander_init(void *unused) |
| { |
| if (CONFIG(BOARD_INTEL_KBLRVP11)) |
| return; |
| |
| printk(BIOS_DEBUG, "Programming TCA6424A I/O expander\n"); |
| |
| /* I/O Expander 1, Port 0 Data */ |
| i2c_writeb(IO_EXPANDER_BUS, IO_EXPANDER_0_ADDR, IO_EXPANDER_P0DOUT, |
| 0xF7); |
| /* Port 0 Configuration */ |
| i2c_writeb(IO_EXPANDER_BUS, IO_EXPANDER_0_ADDR, IO_EXPANDER_P0CONF, |
| 0xE0); |
| |
| /* Port 1 Data */ |
| i2c_writeb(IO_EXPANDER_BUS, IO_EXPANDER_0_ADDR, IO_EXPANDER_P1DOUT, |
| 0x9E); |
| /* Port 1 Configuration */ |
| i2c_writeb(IO_EXPANDER_BUS, IO_EXPANDER_0_ADDR, IO_EXPANDER_P1CONF, |
| 0x8C); |
| |
| /* Port 2 Data */ |
| i2c_writeb(IO_EXPANDER_BUS, IO_EXPANDER_0_ADDR, IO_EXPANDER_P2DOUT, |
| 0xDA); |
| /* Port 2 Configuration */ |
| i2c_writeb(IO_EXPANDER_BUS, IO_EXPANDER_0_ADDR, IO_EXPANDER_P2CONF, |
| 0x08); |
| |
| /* I/O Expander 2, Port 0 Data */ |
| i2c_writeb(IO_EXPANDER_BUS, IO_EXPANDER_1_ADDR, IO_EXPANDER_P0DOUT, |
| 0xFF); |
| /* Port 0 Configuration */ |
| i2c_writeb(IO_EXPANDER_BUS, IO_EXPANDER_1_ADDR, IO_EXPANDER_P0CONF, |
| 0x00); |
| } |
| |
| BOOT_STATE_INIT_ENTRY(BS_POST_DEVICE, BS_ON_EXIT, ioexpander_init, NULL); |