| /* SPDX-License-Identifier: GPL-2.0-only */ |
| |
| /* |
| * This file is created based on Intel Alder Lake Processor PCH Datasheet |
| * Document number: 621483 |
| * Chapter number: 2 |
| */ |
| |
| #include <device/pci.h> |
| #include <pc80/isa-dma.h> |
| #include <pc80/i8259.h> |
| #include <arch/ioapic.h> |
| #include <intelblocks/itss.h> |
| #include <intelblocks/lpc_lib.h> |
| #include <intelblocks/pcr.h> |
| #include <soc/espi.h> |
| #include <soc/iomap.h> |
| #include <soc/irq.h> |
| #include <soc/pci_devs.h> |
| #include <soc/pcr_ids.h> |
| #include <soc/soc_chip.h> |
| |
| /* |
| * As per the BWG, Chapter 5.9.1. "PCH BIOS component will reserve |
| * certain memory range as reserved range for BIOS usage. |
| * For this SOC, the range will be from 0FC800000h till FE7FFFFFh" |
| */ |
| static const struct lpc_mmio_range lpc_fixed_mmio_ranges[] = { |
| { PCH_PRESERVED_BASE_ADDRESS, PCH_PRESERVED_BASE_SIZE }, |
| { 0, 0 } |
| }; |
| |
| const struct lpc_mmio_range *soc_get_fixed_mmio_ranges() |
| { |
| return lpc_fixed_mmio_ranges; |
| } |
| |
| void soc_get_gen_io_dec_range(const struct device *dev, uint32_t *gen_io_dec) |
| { |
| const config_t *config = config_of(dev); |
| |
| gen_io_dec[0] = config->gen1_dec; |
| gen_io_dec[1] = config->gen2_dec; |
| gen_io_dec[2] = config->gen3_dec; |
| gen_io_dec[3] = config->gen4_dec; |
| } |
| |
| void soc_setup_dmi_pcr_io_dec(uint32_t *gen_io_dec) |
| { |
| /* Mirror these same settings in DMI PCR */ |
| pcr_write32(PID_DMI, PCR_DMI_LPCLGIR1, gen_io_dec[0]); |
| pcr_write32(PID_DMI, PCR_DMI_LPCLGIR2, gen_io_dec[1]); |
| pcr_write32(PID_DMI, PCR_DMI_LPCLGIR3, gen_io_dec[2]); |
| pcr_write32(PID_DMI, PCR_DMI_LPCLGIR4, gen_io_dec[3]); |
| } |
| |
| #if ENV_RAMSTAGE |
| void lpc_soc_init(struct device *dev) |
| { |
| /* Legacy initialization */ |
| isa_dma_init(); |
| lpc_pch_misc_init(); |
| |
| /* Enable CLKRUN_EN for power gating ESPI */ |
| lpc_enable_pci_clk_cntl(); |
| |
| /* Set ESPI Serial IRQ mode */ |
| if (CONFIG(SERIRQ_CONTINUOUS_MODE)) |
| lpc_set_serirq_mode(SERIRQ_CONTINUOUS); |
| else |
| lpc_set_serirq_mode(SERIRQ_QUIET); |
| |
| /* Interrupt configuration */ |
| lpc_pch_enable_ioapic(); |
| lpc_pch_pirq_init(); |
| setup_i8259(); |
| i8259_configure_irq_trigger(9, 1); |
| } |
| #endif |