| /* SPDX-License-Identifier: GPL-2.0-only */ |
| |
| #include <stdint.h> |
| #include <console/console.h> |
| #include <device/pci_ops.h> |
| #include <device/smbus_host.h> |
| #include <southbridge/intel/common/gpio.h> |
| #include <southbridge/intel/common/pmbase.h> |
| #include "i82801gx.h" |
| #include "chip.h" |
| |
| void i82801gx_lpc_setup(void) |
| { |
| const pci_devfn_t d31f0 = PCI_DEV(0, 0x1f, 0); |
| const struct device *dev = pcidev_on_root(0x1f, 0); |
| const struct southbridge_intel_i82801gx_config *config; |
| |
| /* Configure serial IRQs.*/ |
| pci_write_config8(d31f0, SERIRQ_CNTL, 0xd0); |
| /* |
| * Enable some common LPC IO ranges: |
| * - 0x2e/0x2f, 0x4e/0x4f often SuperIO |
| * - 0x60/0x64, 0x62/0x66 often KBC/EC |
| * - 0x3f0-0x3f5/0x3f7 FDD |
| * - 0x378-0x37f and 0x778-0x77f LPT |
| * - 0x2f8-0x2ff COMB |
| * - 0x3f8-0x3ff COMA |
| * - 0x208-0x20f GAMEH |
| * - 0x200-0x207 GAMEL |
| */ |
| pci_write_config16(d31f0, LPC_IO_DEC, 0x0010); |
| pci_write_config16(d31f0, LPC_EN, CNF2_LPC_EN | CNF1_LPC_EN |
| | MC_LPC_EN | KBC_LPC_EN | GAMEH_LPC_EN |
| | GAMEL_LPC_EN | FDD_LPC_EN | LPT_LPC_EN |
| | COMB_LPC_EN | COMA_LPC_EN); |
| |
| /* Set up generic decode ranges */ |
| if (!dev || !dev->chip_info) |
| return; |
| config = dev->chip_info; |
| |
| pci_write_config32(d31f0, GEN1_DEC, config->gen1_dec); |
| pci_write_config32(d31f0, GEN2_DEC, config->gen2_dec); |
| pci_write_config32(d31f0, GEN3_DEC, config->gen3_dec); |
| pci_write_config32(d31f0, GEN4_DEC, config->gen4_dec); |
| } |
| |
| void i82801gx_setup_bars(void) |
| { |
| const pci_devfn_t d31f0 = PCI_DEV(0, 0x1f, 0); |
| pci_write_config32(d31f0, RCBA, (uint32_t)DEFAULT_RCBA | 1); |
| pci_write_config32(d31f0, PMBASE, DEFAULT_PMBASE | 1); |
| pci_write_config8(d31f0, ACPI_CNTL, ACPI_EN); |
| |
| pci_write_config32(d31f0, GPIOBASE, DEFAULT_GPIOBASE | 1); |
| pci_write_config8(d31f0, GPIO_CNTL, GPIO_EN); |
| } |
| |
| #define TCO_BASE 0x60 |
| |
| #if ENV_ROMSTAGE |
| void i82801gx_early_init(void) |
| { |
| uint8_t reg8; |
| uint32_t reg32; |
| |
| enable_smbus(); |
| |
| printk(BIOS_DEBUG, "Setting up static southbridge registers..."); |
| i82801gx_setup_bars(); |
| |
| setup_pch_gpios(&mainboard_gpio_map); |
| printk(BIOS_DEBUG, " done.\n"); |
| |
| printk(BIOS_DEBUG, "Disabling Watchdog reboot..."); |
| RCBA32(GCS) = RCBA32(GCS) | (1 << 5); /* No reset */ |
| write_pmbase16(TCO_BASE + 0x8, (1 << 11)); /* halt timer */ |
| write_pmbase16(TCO_BASE + 0x4, (1 << 3)); /* clear timeout */ |
| write_pmbase16(TCO_BASE + 0x6, (1 << 1)); /* clear 2nd timeout */ |
| printk(BIOS_DEBUG, " done.\n"); |
| |
| /* program secondary mlt XXX byte? */ |
| pci_write_config8(PCI_DEV(0, 0x1e, 0), SMLT, 0x20); |
| |
| /* reset rtc power status */ |
| reg8 = pci_read_config8(PCI_DEV(0, 0x1f, 0), GEN_PMCON_3); |
| reg8 &= ~RTC_BATTERY_DEAD; |
| pci_write_config8(PCI_DEV(0, 0x1f, 0), GEN_PMCON_3, reg8); |
| |
| /* USB transient disconnect */ |
| reg8 = pci_read_config8(PCI_DEV(0, 0x1f, 0), 0xad); |
| reg8 |= (3 << 0); |
| pci_write_config8(PCI_DEV(0, 0x1f, 0), 0xad, reg8); |
| |
| reg32 = pci_read_config32(PCI_DEV(0, 0x1d, 7), 0xfc); |
| reg32 |= (1 << 29) | (1 << 17); |
| pci_write_config32(PCI_DEV(0, 0x1d, 7), 0xfc, reg32); |
| |
| reg32 = pci_read_config32(PCI_DEV(0, 0x1d, 7), 0xdc); |
| reg32 |= (1 << 31) | (1 << 27); |
| pci_write_config32(PCI_DEV(0, 0x1d, 7), 0xdc, reg32); |
| |
| /* Enable IOAPIC */ |
| RCBA8(OIC) = 0x03; |
| RCBA8(OIC); |
| |
| /* A lot of CIR bits relate DMI setup which is likely not correctly |
| done for x4x. The issue is also present on ICH10. */ |
| if (!CONFIG(NORTHBRIDGE_INTEL_X4X)) |
| ich7_setup_cir(); |
| } |
| #endif |