src/soc/intel/common/block/pmc/Kconfig

config SOC_INTEL_COMMON_BLOCK_PMC
	depends on SOC_INTEL_COMMON_BLOCK_GPIO
	depends on ACPI_INTEL_HARDWARE_SLEEP_VALUES
	bool
	select HAVE_POWER_STATE_AFTER_FAILURE
	select HAVE_POWER_STATE_PREVIOUS_AFTER_FAILURE
	help
	  Intel Processor common code for Power Management controller(PMC)
	  subsystem

if SOC_INTEL_COMMON_BLOCK_PMC

config POWER_STATE_DEFAULT_ON_AFTER_FAILURE
	default y

config SOC_INTEL_COMMON_BLOCK_PMC_DISCOVERABLE
	bool
	help
	  Select this on platforms where the PMC device is discoverable
	  when scanning busses.

endif # SOC_INTEL_COMMON_BLOCK_PMC

config PMC_INVALID_READ_AFTER_WRITE
	bool
	default n
	help
	  Enable this for PMC devices where a read back of ACPI BAR and
	  IO access bit does not return the previously written value.

config PMC_IPC_ACPI_INTERFACE
	bool
	default n
	depends on HAVE_ACPI_TABLES
	help
	  Enable this to have the PMC IPC mailbox ACPI interface added
	  to the SSDT for use by other drivers.

config PMC_GLOBAL_RESET_ENABLE_LOCK
	bool
	help
	  Enable this for PMC devices where the reset configuration
	  and lock register is located under PMC BASE at offset ETR.
	  Note that the reset register is still at 0xCF9 this only
	  controls the enable and lock feature.

config PMC_LOW_POWER_MODE_PROGRAM
	bool
	help
	  Enable this for PMC devices to perform registers programming
	  to ensure low power in active idle scenario.

config PM_ACPI_TIMER_OPTIONAL
	bool
	default n
	help
	  This needs to be selected by SoCs, where the hardware PM Timer
	  can be disabled, to show the ACPI PM Timer Kconfig in menuconfig.

if PM_ACPI_TIMER_OPTIONAL

config USE_PM_ACPI_TIMER
	bool "Enable ACPI PM timer"
	default y
	help
	  This should be disabled for devices running on battery since
	  it can draw much power. Further, it must be disabled, if S0ix
	  is enabled.

	  Disabling this option also stops the hardware TCO timer and makes
	  the TCO watchdog unavailable.

endif # PM_ACPI_TIMER_OPTIONAL