Paul Menzel | 2628571 | 2017-04-17 10:57:51 +0200 | [diff] [blame] | 1 | Failed Operating systems: |
| 2 | - Xubuntu 16.04 - Starts to boot, reboots when initializing CPU 1. See below. |
| 3 | Linux kernel 4.4.0-34-generic |
| 4 | - Mint 17.2 - Starts to boot, reboots when initializing CPU 1. |
| 5 | Linux kernel 3.16.0-38-generic |
| 6 | - Windows XP - No vBIOS in this image - Hangs at "Setup is starting" |
| 7 | - Android x86 4.4 - Hangs immediately - no output. |
| 8 | - Bits 2074 - Reboots immediately - no output. |
| 9 | - FreeBSD 10.0 - Starts to boot, reboots when loading ACPI table |
| 10 | - OpenBSD 5.0 - Starts to boot, reboots when initializing CPU 1 |
| 11 | |
| 12 | Booted Operating systems: |
| 13 | - Xubuntu 16.04 - Booted with 'acpi=off' kernel parameter. 1 CPU only. |
| 14 | - Mint 17.2 - Booted with 'acpi=off' kernel parameter. 1 CPU only |
| 15 | |
| 16 | DIMM Configurations Passed Boot & Memtest: |
| 17 | - Slot 1: Empty Slot 2 - 1024 MB DDR2-666 ECC - Micron |
| 18 | - Slot 1: 1024 MB DDR2-666 Super Talent Slot 2 - Empty |
| 19 | - Slot 1: 4096 MB DDR2-666 ECC - Kingst Slot 2 - Empty |
| 20 | - Slot 1: 1024 MB DDR2-800 Micron Slot 2 - 1024 MB DDR2-800 Micron |
| 21 | |
| 22 | DIMM Configurations Failed Boot: |
| 23 | - Slot 1: Empty Slot 2 - 4096 MB DDR2-666 ECC - Kingston |
| 24 | |
| 25 | PCI/PCIe slots Passed (MSI enabled) |
| 26 | - Network cards worked correctly in all slots |
| 27 | |
| 28 | Graphics Passed: |
| 29 | - Internal graphics works under linux |
| 30 | |
| 31 | USB Passed: |
| 32 | - All rear ports |
| 33 | |
| 34 | Hardware not tested: |
| 35 | - Front USB ports |
| 36 | - PS/2 ports |
| 37 | - Sata ports |
| 38 | - Pata port |
| 39 | - LPT port |
| 40 | - Floppy port |
| 41 | - Audio |
| 42 | |
| 43 | Summary: |
| 44 | - ACPI is borked. To boot linux, I needed to add the "acpi=off" kernel command |
| 45 | line parameter or the system would get to the point where it was trying |
| 46 | to set up the other cores, and it would reboot. |
| 47 | - The ACPI issue prevented the timestamp data from being generated. |
| 48 | - The ACPI issue prevented the 2nd core on my system from being brought up. |
| 49 | |
| 50 | FWTS lists 42 failures. Major failures: |
| 51 | - SCI_EN bit in PM1a Control Register Block is not enabled. |
| 52 | - madt: MADT revision is not in sync with the FADT revision; |
| 53 | - MADT 1 expects FADT 3.0 but found 4.0 instead. |
| 54 | - apicedge: Non-Legacy interrupt 0 is incorrectly level triggered. |
| 55 | - apicedge: Non-Legacy interrupt 1 is incorrectly level triggered. |
| 56 | - apicedge: Non-Legacy interrupt 2 is incorrectly level triggered. |
| 57 | - apicedge: Non-Legacy interrupt 4 is incorrectly level triggered. |
| 58 | - apicedge: Non-Legacy interrupt 7 is incorrectly level triggered. |
| 59 | - apicedge: Non-Legacy interrupt 8 is incorrectly level triggered. |
| 60 | - apicedge: Non-Legacy interrupt 11 is incorrectly level triggered. |
| 61 | |
| 62 | |
| 63 | Linux boot failure: |
| 64 | [ 0.212000] smpboot: CPU0: Intel Pentium(R) Dual-Core CPU E5400 @ 2.70GHz (family: 0x6, model: 0x17, stepping: 0xa) |
| 65 | [ 0.216017] Performance Events: PEBS fmt0+, 4-deep LBR, Core2 events, Intel PMU driver. |
| 66 | [ 0.228005] ... version: 2 |
| 67 | [ 0.232002] ... bit width: 40 |
| 68 | [ 0.236002] ... generic registers: 2 |
| 69 | [ 0.240003] ... value mask: 000000ffffffffff |
| 70 | [ 0.244002] ... max period: 000000007fffffff |
| 71 | [ 0.248002] ... fixed-purpose events: 3 |
| 72 | [ 0.252002] ... event mask: 0000000700000003 |
| 73 | [ 0.258110] x86: Booting SMP configuration: |
| 74 | [ 0.260009] .... node #0, CPUs: #1 |
| 75 | |
| 76 | coreboot-4.4-1462-gba349ab Sun Sep 11 12:27:42 UTC 2016 romstage starting... |