| Failed Operating systems: |
| - Xubuntu 16.04 - Starts to boot, reboots when initializing CPU 1. See below. |
| Linux kernel 4.4.0-34-generic |
| - Mint 17.2 - Starts to boot, reboots when initializing CPU 1. |
| Linux kernel 3.16.0-38-generic |
| - Windows XP - No vBIOS in this image - Hangs at "Setup is starting" |
| - Android x86 4.4 - Hangs immediately - no output. |
| - Bits 2074 - Reboots immediately - no output. |
| - FreeBSD 10.0 - Starts to boot, reboots when loading ACPI table |
| - OpenBSD 5.0 - Starts to boot, reboots when initializing CPU 1 |
| |
| Booted Operating systems: |
| - Xubuntu 16.04 - Booted with 'acpi=off' kernel parameter. 1 CPU only. |
| - Mint 17.2 - Booted with 'acpi=off' kernel parameter. 1 CPU only |
| |
| DIMM Configurations Passed Boot & Memtest: |
| - Slot 1: Empty Slot 2 - 1024 MB DDR2-666 ECC - Micron |
| - Slot 1: 1024 MB DDR2-666 Super Talent Slot 2 - Empty |
| - Slot 1: 4096 MB DDR2-666 ECC - Kingst Slot 2 - Empty |
| - Slot 1: 1024 MB DDR2-800 Micron Slot 2 - 1024 MB DDR2-800 Micron |
| |
| DIMM Configurations Failed Boot: |
| - Slot 1: Empty Slot 2 - 4096 MB DDR2-666 ECC - Kingston |
| |
| PCI/PCIe slots Passed (MSI enabled) |
| - Network cards worked correctly in all slots |
| |
| Graphics Passed: |
| - Internal graphics works under linux |
| |
| USB Passed: |
| - All rear ports |
| |
| Hardware not tested: |
| - Front USB ports |
| - PS/2 ports |
| - Sata ports |
| - Pata port |
| - LPT port |
| - Floppy port |
| - Audio |
| |
| Summary: |
| - ACPI is borked. To boot linux, I needed to add the "acpi=off" kernel command |
| line parameter or the system would get to the point where it was trying |
| to set up the other cores, and it would reboot. |
| - The ACPI issue prevented the timestamp data from being generated. |
| - The ACPI issue prevented the 2nd core on my system from being brought up. |
| |
| FWTS lists 42 failures. Major failures: |
| - SCI_EN bit in PM1a Control Register Block is not enabled. |
| - madt: MADT revision is not in sync with the FADT revision; |
| - MADT 1 expects FADT 3.0 but found 4.0 instead. |
| - apicedge: Non-Legacy interrupt 0 is incorrectly level triggered. |
| - apicedge: Non-Legacy interrupt 1 is incorrectly level triggered. |
| - apicedge: Non-Legacy interrupt 2 is incorrectly level triggered. |
| - apicedge: Non-Legacy interrupt 4 is incorrectly level triggered. |
| - apicedge: Non-Legacy interrupt 7 is incorrectly level triggered. |
| - apicedge: Non-Legacy interrupt 8 is incorrectly level triggered. |
| - apicedge: Non-Legacy interrupt 11 is incorrectly level triggered. |
| |
| |
| Linux boot failure: |
| [ 0.212000] smpboot: CPU0: Intel Pentium(R) Dual-Core CPU E5400 @ 2.70GHz (family: 0x6, model: 0x17, stepping: 0xa) |
| [ 0.216017] Performance Events: PEBS fmt0+, 4-deep LBR, Core2 events, Intel PMU driver. |
| [ 0.228005] ... version: 2 |
| [ 0.232002] ... bit width: 40 |
| [ 0.236002] ... generic registers: 2 |
| [ 0.240003] ... value mask: 000000ffffffffff |
| [ 0.244002] ... max period: 000000007fffffff |
| [ 0.248002] ... fixed-purpose events: 3 |
| [ 0.252002] ... event mask: 0000000700000003 |
| [ 0.258110] x86: Booting SMP configuration: |
| [ 0.260009] .... node #0, CPUs: #1 |
| |
| coreboot-4.4-1462-gba349ab Sun Sep 11 12:27:42 UTC 2016 romstage starting... |