esp-scsi: handle non-DMA SCSI commands with no data phase
The existing esp-scsi state machine checks for the STAT_TC bit to exit state 1
but in the case where there is no data phase, a non-DMA command is executed
which doesn't set STAT_TC. This only works because QEMU currently always sets
STAT_TC just after issuing every SCSI command.
Update the esp-scsi state machine so that in the case where there is no data
phase, we immediately execute CMD_ICCS instead of waiting for STAT_TC to be
set which will never happen with a non-DMA CMD_SELATN command.
Signed-off-by: Mark Cave-Ayland <mark.cave-ayland@ilande.co.uk>
Message-ID: <20230807065300.366070-4-mark.cave-ayland@ilande.co.uk>
Signed-off-by: Gerd Hoffmann <kraxel@redhat.com>
diff --git a/src/hw/esp-scsi.c b/src/hw/esp-scsi.c
index ebdbd02..f19804f 100644
--- a/src/hw/esp-scsi.c
+++ b/src/hw/esp-scsi.c
@@ -137,6 +137,9 @@
esp_scsi_dma(iobase, (u32)op->buf_fl, count, scsi_is_read(op));
outb(ESP_CMD_TI | ESP_CMD_DMA, iobase + ESP_CMD);
continue;
+ } else {
+ /* No data phase. */
+ state++;
}
}
}
@@ -144,12 +147,18 @@
/* At end of DMA TC is set again -> complete command. */
if (state == 1 && (stat & ESP_STAT_TC)) {
state++;
+ continue;
+ }
+
+ /* Request message in data. */
+ if (state == 2) {
+ state++;
outb(ESP_CMD_ICCS, iobase + ESP_CMD);
continue;
}
/* Finally read data from the message in phase. */
- if (state == 2 && (stat & ESP_STAT_MSG)) {
+ if (state == 3 && (stat & ESP_STAT_MSG)) {
state++;
status = inb(iobase + ESP_FIFO);
inb(iobase + ESP_FIFO);