src/mainboard/gigabyte/m57sli/romstage.c

/*
 * This file is part of the coreboot project.
 *
 * Copyright (C) 2007 AMD
 * Written by Yinghai Lu <yinghailu@amd.com> for AMD.
 *
 * This program is free software; you can redistribute it and/or modify
 * it under the terms of the GNU General Public License as published by
 * the Free Software Foundation; either version 2 of the License, or
 * (at your option) any later version.
 *
 * This program is distributed in the hope that it will be useful,
 * but WITHOUT ANY WARRANTY; without even the implied warranty of
 * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
 * GNU General Public License for more details.
 *
 * You should have received a copy of the GNU General Public License
 * along with this program; if not, write to the Free Software
 * Foundation, Inc., 51 Franklin St, Fifth Floor, Boston, MA  02110-1301 USA
 */

#if CONFIG_K8_REV_F_SUPPORT
#define K8_REV_F_SUPPORT_F0_F1_WORKAROUND 0
#endif

#include <stdint.h>
#include <string.h>
#include <device/pci_def.h>
#include <device/pci_ids.h>
#include <arch/io.h>
#include <device/pnp_def.h>
#include <arch/romcc_io.h>
#include <cpu/x86/lapic.h>
#include <pc80/mc146818rtc.h>
#include <console/console.h>
#include <spd.h>
#include <cpu/amd/model_fxx_rev.h>
#include "southbridge/nvidia/mcp55/early_smbus.c"
#include "northbridge/amd/amdk8/raminit.h"
#include "lib/delay.c"
#include "cpu/x86/lapic/boot_cpu.c"
#include "northbridge/amd/amdk8/reset_test.c"
#include "superio/ite/it8716f/early_serial.c"
#include "superio/ite/it8716f/early_init.c"
#include "cpu/x86/bist.h"
#include "northbridge/amd/amdk8/debug.c"
#include "cpu/x86/mtrr/earlymtrr.c"
#include "northbridge/amd/amdk8/setup_resource_map.c"
#include "southbridge/nvidia/mcp55/early_ctrl.c"

#define SERIAL_DEV PNP_DEV(0x2e, IT8716F_SP1)
#define GPIO_DEV PNP_DEV(0x2e, IT8716F_GPIO)

static void memreset(int controllers, const struct mem_controller *ctrl) { }
static void activate_spd_rom(const struct mem_controller *ctrl) { }

static inline int spd_read_byte(unsigned device, unsigned address)
{
	return smbus_read_byte(device, address);
}

#define MCP55_MB_SETUP \
        RES_PORT_IO_8, SYSCTRL_IO_BASE + 0xc0+37, 0x00, 0x68,/* GPIO38 PCI_REQ3 */ \
        RES_PORT_IO_8, SYSCTRL_IO_BASE + 0xc0+38, 0x00, 0x68,/* GPIO39 PCI_GNT3 */ \
        RES_PORT_IO_8, SYSCTRL_IO_BASE + 0xc0+39, 0x00, 0x68,/* GPIO40 PCI_GNT2 */ \
        RES_PORT_IO_8, SYSCTRL_IO_BASE + 0xc0+40, 0x00, 0x68,/* GPIO41 PCI_REQ2 */ \
        RES_PORT_IO_8, SYSCTRL_IO_BASE + 0xc0+59, 0x00, 0x60,/* GPIP60 FANCTL0 */ \
        RES_PORT_IO_8, SYSCTRL_IO_BASE + 0xc0+60, 0x00, 0x60,/* GPIO61 FANCTL1 */

#include "southbridge/nvidia/mcp55/early_setup_ss.h"
#include "southbridge/nvidia/mcp55/early_setup_car.c"
#include "northbridge/amd/amdk8/f.h"
#include "northbridge/amd/amdk8/incoherent_ht.c"
#include "northbridge/amd/amdk8/coherent_ht.c"
#include "northbridge/amd/amdk8/raminit_f.c"
#include "lib/generic_sdram.c"
#include "resourcemap.c"
#include "cpu/amd/dualcore/dualcore.c"
#include "cpu/amd/car/post_cache_as_ram.c"
#include "cpu/amd/model_fxx/init_cpus.c"
#include "cpu/amd/model_fxx/fidvid.c"
#include "northbridge/amd/amdk8/early_ht.c"

static void sio_setup(void)
{
        uint32_t dword;
        uint8_t byte;

        byte = pci_read_config8(PCI_DEV(0, MCP55_DEVN_BASE+1 , 0), 0x7b);
        byte |= 0x20;
        pci_write_config8(PCI_DEV(0, MCP55_DEVN_BASE+1 , 0), 0x7b, byte);

        dword = pci_read_config32(PCI_DEV(0, MCP55_DEVN_BASE+1 , 0), 0xa0);
        dword |= (1<<0);
        pci_write_config32(PCI_DEV(0, MCP55_DEVN_BASE+1 , 0), 0xa0, dword);

        dword = pci_read_config32(PCI_DEV(0, MCP55_DEVN_BASE+1 , 0), 0xa4);
        dword |= (1<<16);
        pci_write_config32(PCI_DEV(0, MCP55_DEVN_BASE+1 , 0), 0xa4, dword);
}

void cache_as_ram_main(unsigned long bist, unsigned long cpu_init_detectedx)
{
	static const uint16_t spd_addr [] = {
		// Node 0
		DIMM0, DIMM2, 0, 0,
		DIMM1, DIMM3, 0, 0,
		// Node 1
		DIMM4, DIMM6, 0, 0,
		DIMM5, DIMM7, 0, 0,
	};

        struct sys_info *sysinfo = &sysinfo_car;
        int needs_reset = 0;
        unsigned bsp_apicid = 0;
	uint8_t tmp = 0;

        if (!cpu_init_detectedx && boot_cpu()) {
		/* Nothing special needs to be done to find bus 0 */
		/* Allow the HT devices to be found */
		enumerate_ht_chain();
		sio_setup();
        }

        if (bist == 0)
		bsp_apicid = init_cpus(cpu_init_detectedx, sysinfo);

	pnp_enter_ext_func_mode(SERIAL_DEV);
	/* The following line will set CLKIN to 24 MHz, external */
	pnp_write_config(SERIAL_DEV, IT8716F_CONFIG_REG_CLOCKSEL, 0x11);
	tmp = pnp_read_config(SERIAL_DEV, IT8716F_CONFIG_REG_SWSUSP);
	/* Is serial flash enabled? Then enable writing to serial flash. */
	if (tmp & 0x0e) {
		pnp_write_config(SERIAL_DEV, IT8716F_CONFIG_REG_SWSUSP, tmp | 0x10);
		pnp_set_logical_device(GPIO_DEV);
		/* Set Serial Flash interface to 0x0820 */
		pnp_write_config(GPIO_DEV, 0x64, 0x08);
		pnp_write_config(GPIO_DEV, 0x65, 0x20);
	}
 	it8716f_enable_dev(SERIAL_DEV, CONFIG_TTYS0_BASE);
	pnp_exit_ext_func_mode(SERIAL_DEV);

        setup_mb_resource_map();

        console_init();

	/* Halt if there was a built in self test failure */
	report_bist_failure(bist);

	printk(BIOS_DEBUG, "*sysinfo range: [%p,%p]\n",sysinfo,sysinfo+1);

        print_debug("bsp_apicid="); print_debug_hex8(bsp_apicid); print_debug("\n");

#if CONFIG_MEM_TRAIN_SEQ == 1
        set_sysinfo_in_ram(0); // in BSP so could hold all ap until sysinfo is in ram
#endif
        setup_coherent_ht_domain(); // routing table and start other core0

        wait_all_core0_started();
#if CONFIG_LOGICAL_CPUS
        // It is said that we should start core1 after all core0 launched
        /* becase optimize_link_coherent_ht is moved out from setup_coherent_ht_domain,
         * So here need to make sure last core0 is started, esp for two way system,
         * (there may be apic id conflicts in that case)
         */
        start_other_cores();
        wait_all_other_cores_started(bsp_apicid);
#endif

        /* it will set up chains and store link pair for optimization later */
        ht_setup_chains_x(sysinfo); // it will init sblnk and sbbusn, nodes, sbdn

#if CONFIG_SET_FIDVID
        {
                msr_t msr;
                msr=rdmsr(0xc0010042);
                print_debug("begin msr fid, vid "); print_debug_hex32( msr.hi ); print_debug_hex32(msr.lo); print_debug("\n");
        }
        enable_fid_change();
        enable_fid_change_on_sb(sysinfo->sbbusn, sysinfo->sbdn);
        init_fidvid_bsp(bsp_apicid);
        // show final fid and vid
        {
                msr_t msr;
                msr=rdmsr(0xc0010042);
                print_debug("end   msr fid, vid "); print_debug_hex32( msr.hi ); print_debug_hex32(msr.lo); print_debug("\n");
        }
#endif

	init_timer(); // Need to use TMICT to synconize FID/VID

        needs_reset |= optimize_link_coherent_ht();
        needs_reset |= optimize_link_incoherent_ht(sysinfo);
        needs_reset |= mcp55_early_setup_x();

        // fidvid change will issue one LDTSTOP and the HT change will be effective too
        if (needs_reset) {
                print_info("ht reset -\n");
              	soft_reset();
        }
        allow_all_aps_stop(bsp_apicid);

        //It's the time to set ctrl in sysinfo now;
	fill_mem_ctrl(sysinfo->nodes, sysinfo->ctrl, spd_addr);

        enable_smbus();

        /* all ap stopped? */

        sdram_initialize(sysinfo->nodes, sysinfo->ctrl, sysinfo);

        post_cache_as_ram(); // bsp swtich stack to ram and copy sysinfo ram now
}