diff --git a/src/mainboard/google/brya/variants/gaelin/gpio.c b/src/mainboard/google/brya/variants/gaelin/gpio.c
index 1438975..29abff3 100644
--- a/src/mainboard/google/brya/variants/gaelin/gpio.c
+++ b/src/mainboard/google/brya/variants/gaelin/gpio.c
@@ -26,15 +26,15 @@
 	PAD_NC(GPP_B3, NONE),
 	/* B4  : PROC_GP3 ==> SSD_PERST_L */
 	PAD_CFG_GPO(GPP_B4, 1, DEEP),
-	/* B7  : ISH_12C1_SDA ==> NC */
-	PAD_NC(GPP_B7, NONE),
-	/* B8  : ISH_I2C1_SCL ==> NC */
-	PAD_NC(GPP_B8, NONE),
+	/* B7  : ISH_I2C1_SDA ==> I2C_TCHSCR_SDA */
+	PAD_CFG_NF(GPP_B7, NONE, DEEP, NF2),
+	/* B8  : ISH_I2C1_SCL ==> I2C_TCHSCR_SCL */
+	PAD_CFG_NF(GPP_B8, NONE, DEEP, NF2),
 
-	/* C6  : SML1CLK ==> USI_RST_L */
-	PAD_CFG_GPO(GPP_C6, 0, DEEP),
+	/* C6  : SML1CLK ==> USI_EN_PWR */
+	PAD_CFG_GPO(GPP_C6, 1, DEEP),
 	/* C7  : SML1DATA ==> USI_INT_L */
-	PAD_CFG_GPO(GPP_C7, 0, DEEP),
+	PAD_CFG_GPI_APIC(GPP_C7, NONE, PLTRST, LEVEL, NONE),
 
 	/* D0  : ISH_GP0 ==> NC */
 	PAD_NC(GPP_D0, NONE),
diff --git a/src/mainboard/google/brya/variants/gaelin/overridetree.cb b/src/mainboard/google/brya/variants/gaelin/overridetree.cb
index 6a572d3f..c36e983 100644
--- a/src/mainboard/google/brya/variants/gaelin/overridetree.cb
+++ b/src/mainboard/google/brya/variants/gaelin/overridetree.cb
@@ -13,7 +13,7 @@
 		[PchSerialIoIndexI2C0] = PchSerialIoPci,
 		[PchSerialIoIndexI2C1] = PchSerialIoPci,
 		[PchSerialIoIndexI2C2] = PchSerialIoDisabled,
-		[PchSerialIoIndexI2C3] = PchSerialIoDisabled,
+		[PchSerialIoIndexI2C3] = PchSerialIoPci,
 		[PchSerialIoIndexI2C4] = PchSerialIoDisabled,
 		[PchSerialIoIndexI2C5] = PchSerialIoDisabled,
 	}"
@@ -41,6 +41,7 @@
 	#| I2C1              | cr50 TPM. Early init is   |
 	#|                   | required to set up a BAR  |
 	#|                   | for TPM communication     |
+	#| I2C3              | TouchScreen               |
 	#+-------------------+---------------------------+
 	register "common_soc_config" = "{
 		.i2c[0] = {
@@ -53,6 +54,12 @@
 			.fall_time_ns = 400,
 			.data_hold_time_ns = 50,
 		},
+		.i2c[3] = {
+			.speed = I2C_SPEED_FAST,
+			.rise_time_ns = 600,
+			.fall_time_ns = 400,
+			.data_hold_time_ns = 50,
+		},
 	}"
 
 	device domain 0 on
@@ -184,6 +191,18 @@
 				device i2c 1a on end
 			end # Audio Nau8825
 		end # I2C0
+		device ref i2c3 on
+			chip drivers/i2c/hid
+				register "generic.hid" = ""LM230001""
+				register "generic.desc" = ""LM238 Touchscreen""
+				register "generic.irq" = "ACPI_IRQ_LEVEL_LOW(GPP_C7_IRQ)"
+				register "generic.probed" = "1"
+				register "generic.enable_gpio" = "ACPI_GPIO_OUTPUT_ACTIVE_HIGH(GPP_C6)"
+				register "generic.enable_delay_ms" = "6"
+				register "generic.has_power_resource" = "1"
+				device i2c 34 on end
+			end
+		end # I2C3
 		device ref pcie_rp5 on
 			# Enable PCIE 5 using clk 2
 			register "pch_pcie_rp[PCH_RP(5)]" = "{