targets/totalimpact/briq/Config.lb

# Config file for the Total Impact briQ
# This will make a target directory of ./briq

target briq
	
mainboard totalimpact/briq

## Use stage 1 initialization code
option CONFIG_USE_INIT=1

## We don't use compressed image
option CONFIG_COMPRESS=0

## Turn off POST codes
option NO_POST=1

## Enable serial console
option DEFAULT_CONSOLE_LOGLEVEL=8
option CONFIG_CONSOLE_SERIAL8250=1

## Boot linux from IDE
option CONFIG_IDE_STREAM=1
option IDE_BOOT_DRIVE=0
option IDE_SWAB=1
option IDE_OFFSET=0

# ROM is 1Mb
option ROM_SIZE=1048576

# Set stack and heap sizes (stage 2)
option STACK_SIZE=0x10000
option HEAP_SIZE=0x10000

# Sandpoint Demo Board
romimage "normal"
	## Base of ROM
	option _ROMBASE=0xfff00000

	## Sandpoint reset vector
	option _RESET=_ROMBASE+0x100

	## Exception vectors (other than reset vector)
	option _EXCEPTION_VECTORS=_RESET+0x100

	## Start of linuxBIOS in the boot rom
	## = _RESET + exeception vector table size
	option _ROMSTART=_RESET+0x3100

	## LinuxBIOS C code runs at this location in RAM
	option _RAMBASE=0x00100000
	option _RAMSTART=0x00100000

	option CONFIG_BRIQ_750FX=1
	#option CONFIG_BRIQ_7400=1

end

buildrom ./linuxbios.rom ROM_SIZE "normal"