/*
 * This file is part of the coreboot project.
 *
 * Copyright (C) 2007 AMD
 * Written by Yinghai Lu <yinghailu@amd.com> for AMD.
 * Copyright (C) 2007 Silicon Integrated Systems Corp. (SiS)
 * Written by Morgan Tsai <my_tsai@sis.com> for SiS.
 *
 * This program is free software; you can redistribute it and/or modify
 * it under the terms of the GNU General Public License as published by
 * the Free Software Foundation; either version 2 of the License, or
 * (at your option) any later version.
 *
 * This program is distributed in the hope that it will be useful,
 * but WITHOUT ANY WARRANTY; without even the implied warranty of
 * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
 * GNU General Public License for more details.
 */

#include <stdint.h>
#include <string.h>
#include <device/pci_def.h>
#include <device/pci_ids.h>
#include <arch/io.h>
#include <device/pnp_def.h>
#include <cpu/x86/lapic.h>
#include <pc80/mc146818rtc.h>
#include <console/console.h>
#include <spd.h>
#include <cpu/amd/model_fxx_rev.h>
#include <southbridge/sis/sis966/sis966.h>
#include "southbridge/sis/sis966/early_smbus.c"
#include <northbridge/amd/amdk8/raminit.h>
#include <delay.h>
#include <cpu/x86/lapic.h>
#include "northbridge/amd/amdk8/reset_test.c"
#include <superio/ite/common/ite.h>
#include <superio/ite/it8716f/it8716f.h>
#include <cpu/x86/bist.h>
#include "northbridge/amd/amdk8/debug.c"
#include "northbridge/amd/amdk8/setup_resource_map.c"
#include "southbridge/sis/sis966/early_ctrl.c"

#define SERIAL_DEV PNP_DEV(0x2e, IT8716F_SP1)
#define CLKIN_DEV PNP_DEV(0x2e, IT8716F_GPIO)

static void memreset(int controllers, const struct mem_controller *ctrl) { }
static void activate_spd_rom(const struct mem_controller *ctrl) { }

static inline int spd_read_byte(unsigned device, unsigned address)
{
	return smbus_read_byte(device, address);
}

#include <northbridge/amd/amdk8/f.h>
#include "northbridge/amd/amdk8/incoherent_ht.c"
#include "northbridge/amd/amdk8/coherent_ht.c"
#include "northbridge/amd/amdk8/raminit_f.c"
#include "lib/generic_sdram.c"
#include "resourcemap.c"
#include "cpu/amd/dualcore/dualcore.c"

#define SIS966_NUM 1
#define SIS966_USE_NIC 1
#define SIS966_USE_AZA 1

#define SIS966_PCI_E_X_0 0

#define SIS966_MB_SETUP \
        RES_PORT_IO_8, SYSCTRL_IO_BASE + 0xc0+37, 0x00, 0x44,/* GPIO38 PCI_REQ3 */ \
        RES_PORT_IO_8, SYSCTRL_IO_BASE + 0xc0+38, 0x00, 0x44,/* GPIO39 PCI_GNT3 */ \
        RES_PORT_IO_8, SYSCTRL_IO_BASE + 0xc0+39, 0x00, 0x44,/* GPIO40 PCI_GNT2 */ \
        RES_PORT_IO_8, SYSCTRL_IO_BASE + 0xc0+40, 0x00, 0x44,/* GPIO41 PCI_REQ2 */ \
        RES_PORT_IO_8, SYSCTRL_IO_BASE + 0xc0+59, 0x00, 0x60,/* GPIP60 FANCTL0 */ \
        RES_PORT_IO_8, SYSCTRL_IO_BASE + 0xc0+60, 0x00, 0x60,/* GPIO61 FANCTL1 */

#include <southbridge/sis/sis966/early_setup_ss.h>
#include "cpu/amd/model_fxx/init_cpus.c"
#include "cpu/amd/model_fxx/fidvid.c"
#include "northbridge/amd/amdk8/early_ht.c"

static void sio_setup(void)
{
        uint32_t dword;
        uint8_t byte;

        byte = pci_read_config8(PCI_DEV(0, SIS966_DEVN_BASE+1 , 0), 0x7b);
        byte |= 0x20;
        pci_write_config8(PCI_DEV(0, SIS966_DEVN_BASE+1 , 0), 0x7b, byte);

        dword = pci_read_config32(PCI_DEV(0, SIS966_DEVN_BASE+1 , 0), 0xa0);
        dword |= (1<<0);
        pci_write_config32(PCI_DEV(0, SIS966_DEVN_BASE+1 , 0), 0xa0, dword);

        dword = pci_read_config32(PCI_DEV(0, SIS966_DEVN_BASE+1 , 0), 0xa4);
        dword |= (1<<16);
        pci_write_config32(PCI_DEV(0, SIS966_DEVN_BASE+1 , 0), 0xa4, dword);
}

void cache_as_ram_main(unsigned long bist, unsigned long cpu_init_detectedx)
{
	static const uint16_t spd_addr [] = {
		// Node 0
		DIMM0, DIMM2, 0, 0,
		DIMM1, DIMM3, 0, 0,
		// Node 1
		DIMM4, DIMM6, 0, 0,
		DIMM5, DIMM7, 0, 0,
	};

        struct sys_info *sysinfo = &sysinfo_car;
        int needs_reset = 0;
        unsigned bsp_apicid = 0;

        if (!cpu_init_detectedx && boot_cpu()) {
		/* Nothing special needs to be done to find bus 0 */
		/* Allow the HT devices to be found */
		enumerate_ht_chain();
		sio_setup();
        }

        if (bist == 0)
		bsp_apicid = init_cpus(cpu_init_detectedx, sysinfo);

	ite_conf_clkin(CLKIN_DEV, ITE_UART_CLK_PREDIVIDE_48);
	ite_enable_serial(SERIAL_DEV, CONFIG_TTYS0_BASE);

        setup_mb_resource_map();

        console_init();

	/* Halt if there was a built in self test failure */
	report_bist_failure(bist);

	printk(BIOS_DEBUG, "*sysinfo range: [%p,%p]\n",sysinfo,sysinfo+1);

        printk(BIOS_DEBUG, "bsp_apicid=%02x\n", bsp_apicid);

        set_sysinfo_in_ram(0); // in BSP so could hold all ap until sysinfo is in ram
        setup_coherent_ht_domain(); // routing table and start other core0

        wait_all_core0_started();
#if CONFIG_LOGICAL_CPUS
        // It is said that we should start core1 after all core0 launched
        /* becase optimize_link_coherent_ht is moved out from setup_coherent_ht_domain,
         * So here need to make sure last core0 is started, esp for two way system,
         * (there may be apic id conflicts in that case)
         */
        start_other_cores();
        wait_all_other_cores_started(bsp_apicid);
#endif

        /* it will set up chains and store link pair for optimization later */
        ht_setup_chains_x(sysinfo); // it will init sblnk and sbbusn, nodes, sbdn

#if CONFIG_SET_FIDVID
        {
                msr_t msr;
                msr=rdmsr(0xc0010042);
                printk(BIOS_DEBUG, "begin msr fid, vid %08x%08x\n", msr.hi, msr.lo);
        }
        enable_fid_change();
        enable_fid_change_on_sb(sysinfo->sbbusn, sysinfo->sbdn);
        init_fidvid_bsp(bsp_apicid);
        // show final fid and vid
        {
                msr_t msr;
                msr=rdmsr(0xc0010042);
                printk(BIOS_DEBUG, "end   msr fid, vid %08x%08x\n", msr.hi, msr.lo);
        }
#endif

        needs_reset |= optimize_link_coherent_ht();
        needs_reset |= optimize_link_incoherent_ht(sysinfo);

        // fidvid change will issue one LDTSTOP and the HT change will be effective too
        if (needs_reset) {
                printk(BIOS_INFO, "ht reset -\n");
              	soft_reset();
        }
        allow_all_aps_stop(bsp_apicid);

        //It's the time to set ctrl in sysinfo now;
	fill_mem_ctrl(sysinfo->nodes, sysinfo->ctrl, spd_addr);

        sis_init_stage1();
        enable_smbus();

        //do we need apci timer, tsc...., only debug need it for better output
        /* all ap stopped? */
//        init_timer(); // Need to use TMICT to synchronize FID/VID

        sdram_initialize(sysinfo->nodes, sysinfo->ctrl, sysinfo);

        sis_init_stage2();
        post_cache_as_ram(); // bsp swtich stack to ram and copy sysinfo ram now
}