mb/google/zork: Set eMMC presets
They should be tuned per board to get the best signal and boot time.
This fixes the HS400 preset, so it's correctly set to A. It also changes
the SDR50 and DDR50 presets to B. We can't boot correctly when DDR50 is
set to A.
I chose 1 as the init kHz value since that's what depthcharge uses to
calculate the init clock.
BUG=b:159823235
TEST=Boot Ezkinil and dump SDHCI preset registers.
Signed-off-by: Raul E Rangel <rrangel@chromium.org>
Change-Id: Ie2f3497b65d771820ab1a803fec73265547f8906
Reviewed-on: https://review.coreboot.org/c/coreboot/+/45098
Tested-by: build bot (Jenkins) <no-reply@coreboot.org>
Reviewed-by: Marshall Dawson <marshalldawson3rd@gmail.com>
diff --git a/src/mainboard/google/zork/variants/baseboard/devicetree_dalboz.cb b/src/mainboard/google/zork/variants/baseboard/devicetree_dalboz.cb
index 4004243..ae712ee 100644
--- a/src/mainboard/google/zork/variants/baseboard/devicetree_dalboz.cb
+++ b/src/mainboard/google/zork/variants/baseboard/devicetree_dalboz.cb
@@ -42,6 +42,16 @@
register "emmc_config" = "{
.timing = SD_EMMC_EMMC_HS400,
+ .sdr104_hs400_driver_strength = SD_EMMC_DRIVE_STRENGTH_A,
+ /*
+ * The reference design was missing a pull-up on the CMD line.
+ * This means we can't run at the full 400 kHz. By setting this
+ * to 1 we run at the slowest frequency possible by the
+ * controller (~97 kHz).
+ *
+ * Boards that have the pull-up should correctly set this.
+ */
+ .init_khz_preset = 1,
}"
register "xhci0_force_gen1" = "0"