Applying 11_26_car_tyan.diff from Yinghai Lu.
NOTE: This will break the tree so it can be fixed up later
git-svn-id: svn://svn.coreboot.org/coreboot/trunk@2115 2b7e53f0-3cfb-0310-b3e9-8179ed1497e1
diff --git a/src/mainboard/tyan/s2895/Options.lb b/src/mainboard/tyan/s2895/Options.lb
index fc63823..cfb0e13 100644
--- a/src/mainboard/tyan/s2895/Options.lb
+++ b/src/mainboard/tyan/s2895/Options.lb
@@ -52,7 +52,8 @@
uses CONFIG_CHIP_NAME
uses CONFIG_CONSOLE_VGA
uses CONFIG_PCI_ROM_RUN
-uses K8_E0_MEM_HOLE_SIZEK
+uses K8_HW_MEM_HOLE_SIZEK
+uses K8_HT_FREQ_1G_SUPPORT
uses CK804_DEVN_BASE
@@ -61,6 +62,10 @@
uses DCACHE_RAM_SIZE
uses CONFIG_USE_INIT
+uses ENABLE_APIC_EXT_ID
+uses APIC_ID_OFFSET
+uses LIFT_BSP_APIC_ID
+
## ROM_SIZE is the size of boot ROM that this board will use.
#512K bytes
default ROM_SIZE=524288
@@ -71,7 +76,9 @@
##
## FALLBACK_SIZE is the amount of the ROM the complete fallback image will use
##
-default FALLBACK_SIZE=131072
+#default FALLBACK_SIZE=131072
+#256K
+default FALLBACK_SIZE=0x40000
###
### Build options
@@ -124,7 +131,10 @@
#default CONFIG_CHIP_NAME=1
#1G memory hole
-default K8_E0_MEM_HOLE_SIZEK=0x100000
+default K8_HW_MEM_HOLE_SIZEK=0x100000
+
+#Opteron K8 1G HT Support
+default K8_HT_FREQ_1G_SUPPORT=1
#CK804 setting
#default CK804_DEVN_BASE=0
@@ -141,6 +151,11 @@
default DCACHE_RAM_SIZE=0x1000
default CONFIG_USE_INIT=1
+default ENABLE_APIC_EXT_ID=1
+default APIC_ID_OFFSET=0x10
+default LIFT_BSP_APIC_ID=0
+
+
##
## Build code to setup a generic IOAPIC
##