Simplify a few code chunks, fix whitespace and indentation.
Also, remove some less useful comments, some dead code / unused functions.
Signed-off-by: Uwe Hermann <uwe@hermann-uwe.de>
Acked-by: Uwe Hermann <uwe@hermann-uwe.de>
git-svn-id: svn://svn.coreboot.org/coreboot/trunk@6108 2b7e53f0-3cfb-0310-b3e9-8179ed1497e1
diff --git a/src/mainboard/gigabyte/m57sli/romstage.c b/src/mainboard/gigabyte/m57sli/romstage.c
index c959909..968e384 100644
--- a/src/mainboard/gigabyte/m57sli/romstage.c
+++ b/src/mainboard/gigabyte/m57sli/romstage.c
@@ -53,14 +53,8 @@
#define SERIAL_DEV PNP_DEV(0x2e, IT8716F_SP1)
#define GPIO_DEV PNP_DEV(0x2e, IT8716F_GPIO)
-static void memreset(int controllers, const struct mem_controller *ctrl)
-{
-}
-
-static inline void activate_spd_rom(const struct mem_controller *ctrl)
-{
- /* nothing to do */
-}
+static void memreset(int controllers, const struct mem_controller *ctrl) { }
+static void activate_spd_rom(const struct mem_controller *ctrl) { }
static inline int spd_read_byte(unsigned device, unsigned address)
{
@@ -111,17 +105,16 @@
void cache_as_ram_main(unsigned long bist, unsigned long cpu_init_detectedx)
{
static const uint16_t spd_addr [] = {
- // Node 0
- DIMM0, DIMM2, 0, 0,
- DIMM1, DIMM3, 0, 0,
- // Node 1
- DIMM4, DIMM6, 0, 0,
- DIMM5, DIMM7, 0, 0,
+ // Node 0
+ DIMM0, DIMM2, 0, 0,
+ DIMM1, DIMM3, 0, 0,
+ // Node 1
+ DIMM4, DIMM6, 0, 0,
+ DIMM5, DIMM7, 0, 0,
};
struct sys_info *sysinfo = (struct sys_info *)(CONFIG_DCACHE_RAM_BASE
+ CONFIG_DCACHE_RAM_SIZE - CONFIG_DCACHE_RAM_GLOBAL_VAR_SIZE);
-
int needs_reset = 0;
unsigned bsp_apicid = 0;
uint8_t tmp = 0;
@@ -129,18 +122,13 @@
if (!cpu_init_detectedx && boot_cpu()) {
/* Nothing special needs to be done to find bus 0 */
/* Allow the HT devices to be found */
-
enumerate_ht_chain();
-
sio_setup();
-
- /* Setup the mcp55 */
mcp55_enable_rom();
}
- if (bist == 0) {
+ if (bist == 0)
bsp_apicid = init_cpus(cpu_init_detectedx, sysinfo);
- }
pnp_enter_ext_func_mode(SERIAL_DEV);
/* The following line will set CLKIN to 24 MHz, external */
@@ -153,9 +141,6 @@
/* Set Serial Flash interface to 0x0820 */
pnp_write_config(GPIO_DEV, 0x64, 0x08);
pnp_write_config(GPIO_DEV, 0x65, 0x20);
- /* We can get away with not resetting the logical device because
- * it8716f_enable_dev(SERIAL_DEV, CONFIG_TTYS0_BASE) will do that.
- */
}
it8716f_enable_dev(SERIAL_DEV, CONFIG_TTYS0_BASE);
pnp_exit_ext_func_mode(SERIAL_DEV);
@@ -200,21 +185,15 @@
msr_t msr;
msr=rdmsr(0xc0010042);
print_debug("begin msr fid, vid "); print_debug_hex32( msr.hi ); print_debug_hex32(msr.lo); print_debug("\n");
-
}
-
enable_fid_change();
-
enable_fid_change_on_sb(sysinfo->sbbusn, sysinfo->sbdn);
-
init_fidvid_bsp(bsp_apicid);
-
// show final fid and vid
{
msr_t msr;
msr=rdmsr(0xc0010042);
print_debug("end msr fid, vid "); print_debug_hex32( msr.hi ); print_debug_hex32(msr.lo); print_debug("\n");
-
}
#endif