libpayload: Use usb_debug() to show USB messages
Previously printf()'s were used to show USB messages
which results in lots of USB information being shown
when it isn't needed. This will now use the usb_debug()
printing funtion that already exists in usb.h.
Change-Id: I2199814de3327417417eb2e26a660f4a5557cb9f
Signed-off-by: Dave Frodin <dave.frodin@se-eng.com>
Reviewed-on: http://review.coreboot.org/2044
Tested-by: build bot (Jenkins)
Reviewed-by: Anton Kochkov <anton.kochkov@gmail.com>
diff --git a/payloads/libpayload/drivers/usb/usbinit.c b/payloads/libpayload/drivers/usb/usbinit.c
index f95e9c1..2e466d3 100644
--- a/payloads/libpayload/drivers/usb/usbinit.c
+++ b/payloads/libpayload/drivers/usb/usbinit.c
@@ -67,47 +67,47 @@
pci_command |= PCI_COMMAND_MASTER;
pci_write_config32(addr, PCI_COMMAND, pci_command);
- printf("%02x:%02x.%x %04x:%04x.%d ", bus, dev, func,
+ usb_debug("%02x:%02x.%x %04x:%04x.%d ", bus, dev, func,
pciid >> 16, pciid & 0xFFFF, func);
switch (prog_if) {
case 0x00:
#ifdef CONFIG_USB_UHCI
- printf("UHCI controller\n");
+ usb_debug("UHCI controller\n");
uhci_init (addr);
#else
- printf("UHCI controller (not supported)\n");
+ usb_debug("UHCI controller (not supported)\n");
#endif
break;
case 0x10:
#ifdef CONFIG_USB_OHCI
- printf("OHCI controller\n");
+ usb_debug("OHCI controller\n");
ohci_init(addr);
#else
- printf("OHCI controller (not supported)\n");
+ usb_debug("OHCI controller (not supported)\n");
#endif
break;
case 0x20:
#ifdef CONFIG_USB_EHCI
- printf("EHCI controller\n");
+ usb_debug("EHCI controller\n");
ehci_init(addr);
#else
- printf("EHCI controller (not supported)\n");
+ usb_debug("EHCI controller (not supported)\n");
#endif
break;
case 0x30:
#ifdef CONFIG_USB_XHCI
- printf("xHCI controller\n");
+ usb_debug("xHCI controller\n");
xhci_init(addr);
#else
- printf("xHCI controller (not supported)\n");
+ usb_debug("xHCI controller (not supported)\n");
#endif
break;
default:
- printf("unknown controller %x not supported\n",
+ usb_debug("unknown controller %x not supported\n",
prog_if);
break;
}