This page describes how to run coreboot on the ASRock H81M-HDS.
Please see :doc:`../../northbridge/intel/haswell/mrc.bin`.
A fully working image should be possible just by setting your MAC address and obtaining the Haswell mrc. You can set the basic config with the following commands. However, it is strongly advised to use make menuconfig
afterwards (or instead), so that you can see all of the settings.
make distclean # Note: this will remove your current config, if it exists. touch .config ./util/scripts/config --enable VENDOR_ASROCK ./util/scripts/config --enable BOARD_ASROCK_H81M_HDS ./util/scripts/config --enable HAVE_MRC ./util/scripts/config --set-str REALTEK_8168_MACADDRESS "xx:xx:xx:xx:xx:xx" # Fill this in! make olddefconfig
If you don't plan on using coreboot's serial console to collect logs, you might want to disable it at this point (./util/scripts/config --disable CONSOLE_SERIAL
). It should reduce the boot time by several seconds. However, a more flexible method is to change the console log level from within an OS using util/nvramtool
, or with the nvramcui
payload.
Now, run make
to build the coreboot image.
The main SPI flash can be accessed using flashrom. By default, only the BIOS region of the flash is writable. If you wish to change any other region, such as the Management Engine or firmware descriptor, then an external programmer is required (unless you find a clever way around the flash protection).
The following command may be used to flash coreboot:
sudo flashrom -p internal --ifd -i bios --noverify-all -w coreboot.rom
The use of --noverify-all
is required since the Management Engine region is not readable even by the host.
The flash chip is a 4 MiB socketed DIP-8 chip. Specifically, it's a Winbond W25Q32FV, whose datasheet can be found here. The chip is located to the bottom right-hand side of the board. For a precise location, refer to section 1.4 (Motherboard Layout) of the board manual, where the chip is labelled "32Mb BIOS". Take note of the chip's orientation, remove it from its socket, and flash it with an external programmer. For reference, the notch in the chip should be facing towards the bottom of the board.
The VGA port doesn't work until the OS reinitialises the display.
There is no automatic, OS-independent fan control. This is because the super I/O hardware monitor can only obtain valid CPU temperature readings from the PECI agent, but the required driver doesn't exist in coreboot. The coretemp
driver can still be used for accurate CPU temperature readings from an OS.
Please also see :doc:`../../northbridge/intel/haswell/known-issues`.
me_cleaner
+------------------+--------------------------------------------------+ | Northbridge | :doc:`../../northbridge/intel/haswell/index` | +------------------+--------------------------------------------------+ | Southbridge | Intel Lynx Point (H81) | +------------------+--------------------------------------------------+ | CPU | Intel Haswell (LGA1150) | +------------------+--------------------------------------------------+ | Super I/O | Nuvoton NCT6776 | +------------------+--------------------------------------------------+ | EC | None | +------------------+--------------------------------------------------+ | Coprocessor | Intel Management Engine | +------------------+--------------------------------------------------+