chip northbridge/intel/haswell

	# Set panel power delays
	register "gpu_panel_power_cycle_delay_ms" = "400"
	register "gpu_panel_power_up_delay_ms" = "40"
	register "gpu_panel_power_down_delay_ms" = "15"
	register "gpu_panel_power_backlight_on_delay_ms" = "210"
	register "gpu_panel_power_backlight_off_delay_ms" = "210"

	device domain 0 on

		chip southbridge/intel/lynxpoint

			register "sata_devslp_disable" = "0x1"

			# DTLE DATA / EDGE values
			register "sata_port0_gen3_dtle" = "0x5"
			register "sata_port1_gen3_dtle" = "0x5"

			# Disable PCIe CLKOUT 2-5 and CLKOUT_XDP
			register "icc_clock_disable" = "0x013c0000"

			device pci 1f.3 on # SMBus
				chip drivers/i2c/rtd2132
					# Panel Power Timings (1 ms units)
					# Note: the panel Tx timings are very
					# different from the LVDS bridge
					# Tx timing settings. Below is a mapping
					# for RTD2132 -> Panel timings.
					# T1 = T2
					# T2 = T8 + T10 + T12
					# T3 = T14
					# T4 = T15
					# T5 = T9 + T11 + T13
					# T6 = T3
					# T7 = T4
					register "t1" = "0x14"
					register "t2" = "0xdc"
					register "t3" = "0x0e"
					register "t4" = "0x02"
					register "t5" = "0xdc"
					register "t6" = "0x14"
					register "t7" = "0x208"
					# LVDS Swap settings are normal.
					register "lvds_swap" = "0"
					# Enable Spread Sprectrum at 0.5%
					register "sscg_percent" = "0x05"
					device i2c 35 on end # (8bit address: 0x6A)
				end # rtd2132
			end # SMBus
		end
	end
end