config SOC_INTEL_COMMON_BLOCK_PMC
	depends on SOC_INTEL_COMMON_BLOCK_GPIO
	depends on ACPI_INTEL_HARDWARE_SLEEP_VALUES
	bool
	select ACPI_S1_NOT_SUPPORTED
	select HAVE_POWER_STATE_AFTER_FAILURE
	select HAVE_POWER_STATE_PREVIOUS_AFTER_FAILURE
	help
	  Intel Processor common code for Power Management controller(PMC)
	  subsystem

if SOC_INTEL_COMMON_BLOCK_PMC

config SOC_INTEL_MEM_MAPPED_PM_CONFIGURATION
	bool
	help
	  Select this on platforms where the PMC register for PM configuration (i.e.,
	  GEN_PMCON_A/B etc. are memory mapped).

config POWER_STATE_DEFAULT_ON_AFTER_FAILURE
	default y

config SOC_INTEL_COMMON_BLOCK_PMC_DISCOVERABLE
	bool
	help
	  Select this on platforms where the PMC device is discoverable
	  when scanning buses.

config SOC_INTEL_COMMON_BLOCK_PMC_EPOC
	bool
	help
	  Enable this for PMC devices to perform EPOC (CPU Early Power-on
	  Configuration) related functions.

endif # SOC_INTEL_COMMON_BLOCK_PMC

config PMC_INVALID_READ_AFTER_WRITE
	bool
	default n
	help
	  Enable this for PMC devices where a read back of ACPI BAR and
	  IO access bit does not return the previously written value.

config PMC_IPC_ACPI_INTERFACE
	bool
	default n
	depends on HAVE_ACPI_TABLES
	help
	  Enable this to have the PMC IPC mailbox ACPI interface added
	  to the SSDT for use by other drivers.

config PMC_GLOBAL_RESET_ENABLE_LOCK
	bool
	help
	  Enable this for PMC devices where the reset configuration
	  and lock register is located under PMC BASE at offset ETR.
	  Note that the reset register is still at 0xCF9 this only
	  controls the enable and lock feature.

config NO_PM_ACPI_TIMER
	bool
	help
	  Selected by SoCs that do not have a PM ACPI timer.

config USE_PM_ACPI_TIMER
	bool "Enable ACPI PM timer"
	default y
	depends on !NO_PM_ACPI_TIMER
	help
	  This should be disabled for devices running on battery since
	  it can draw much power. Further, it must be disabled, if S0ix
	  is enabled.

	  Disabling this option also stops the hardware TCO timer and makes
	  the TCO watchdog unavailable.

	  Note: On platforms without uCode PM Timer emulation, legacy OSes
	        or payloads with ACPI version < 5.0A might not work without
	        PM ACPI timer.

	        (Legacy) software requiring `TMR_STS` (for timer overflow
	        interrupts) will not work with this option disabled.