mainboard/supermicro/h8dmr/romstage.c: Use tabs for indents
Change-Id: I008ccc5fa9d96e52ee59a4562d81e4f7c1d1a6ac
Signed-off-by: Elyes HAOUAS <ehaouas@noos.fr>
Reviewed-on: https://review.coreboot.org/16775
Tested-by: build bot (Jenkins)
Reviewed-by: Patrick Georgi <pgeorgi@google.com>
diff --git a/src/mainboard/supermicro/h8dmr/romstage.c b/src/mainboard/supermicro/h8dmr/romstage.c
index b137b6b..a7e69bd 100644
--- a/src/mainboard/supermicro/h8dmr/romstage.c
+++ b/src/mainboard/supermicro/h8dmr/romstage.c
@@ -65,24 +65,24 @@
static void sio_setup(void)
{
- uint32_t dword;
- uint8_t byte;
+ uint32_t dword;
+ uint8_t byte;
- enable_smbus();
+ enable_smbus();
// smbusx_write_byte(1, (0x58 >> 1), 0, 0x80); /* select bank0 */
smbusx_write_byte(1, (0x58 >> 1), 0xb1, 0xff); /* set FAN ctrl to DC mode */
- byte = pci_read_config8(PCI_DEV(0, MCP55_DEVN_BASE+1 , 0), 0x7b);
- byte |= 0x20;
- pci_write_config8(PCI_DEV(0, MCP55_DEVN_BASE+1 , 0), 0x7b, byte);
+ byte = pci_read_config8(PCI_DEV(0, MCP55_DEVN_BASE+1 , 0), 0x7b);
+ byte |= 0x20;
+ pci_write_config8(PCI_DEV(0, MCP55_DEVN_BASE+1 , 0), 0x7b, byte);
- dword = pci_read_config32(PCI_DEV(0, MCP55_DEVN_BASE+1 , 0), 0xa0);
- dword |= (1 << 0);
- pci_write_config32(PCI_DEV(0, MCP55_DEVN_BASE+1 , 0), 0xa0, dword);
+ dword = pci_read_config32(PCI_DEV(0, MCP55_DEVN_BASE+1 , 0), 0xa0);
+ dword |= (1 << 0);
+ pci_write_config32(PCI_DEV(0, MCP55_DEVN_BASE+1 , 0), 0xa0, dword);
- dword = pci_read_config32(PCI_DEV(0, MCP55_DEVN_BASE+1 , 0), 0xa4);
- dword |= (1 << 16);
- pci_write_config32(PCI_DEV(0, MCP55_DEVN_BASE+1 , 0), 0xa4, dword);
+ dword = pci_read_config32(PCI_DEV(0, MCP55_DEVN_BASE+1 , 0), 0xa4);
+ dword |= (1 << 16);
+ pci_write_config32(PCI_DEV(0, MCP55_DEVN_BASE+1 , 0), 0xa4, dword);
}
void cache_as_ram_main(unsigned long bist, unsigned long cpu_init_detectedx)
@@ -96,90 +96,90 @@
DIMM5, DIMM7, 0, 0,
};
- struct sys_info *sysinfo = &sysinfo_car;
- int needs_reset = 0;
- unsigned bsp_apicid = 0;
+ struct sys_info *sysinfo = &sysinfo_car;
+ int needs_reset = 0;
+ unsigned bsp_apicid = 0;
- if (!cpu_init_detectedx && boot_cpu()) {
+ if (!cpu_init_detectedx && boot_cpu()) {
/* Nothing special needs to be done to find bus 0 */
/* Allow the HT devices to be found */
enumerate_ht_chain();
sio_setup();
- }
+ }
- if (bist == 0)
+ if (bist == 0)
bsp_apicid = init_cpus(cpu_init_detectedx, sysinfo);
w83627hf_set_clksel_48(DUMMY_DEV);
winbond_enable_serial(SERIAL_DEV, CONFIG_TTYS0_BASE);
- console_init();
+ console_init();
/* Halt if there was a built in self test failure */
report_bist_failure(bist);
printk(BIOS_DEBUG, "*sysinfo range: [%p,%p]\n",sysinfo,sysinfo+1);
- setup_mb_resource_map();
+ setup_mb_resource_map();
- printk(BIOS_DEBUG, "bsp_apicid=%02x\n", bsp_apicid);
+ printk(BIOS_DEBUG, "bsp_apicid=%02x\n", bsp_apicid);
- set_sysinfo_in_ram(0); // in BSP so could hold all ap until sysinfo is in ram
- setup_coherent_ht_domain(); // routing table and start other core0
+ set_sysinfo_in_ram(0); // in BSP so could hold all ap until sysinfo is in ram
+ setup_coherent_ht_domain(); // routing table and start other core0
- wait_all_core0_started();
+ wait_all_core0_started();
#if CONFIG_LOGICAL_CPUS
- // It is said that we should start core1 after all core0 launched
- /* becase optimize_link_coherent_ht is moved out from setup_coherent_ht_domain,
- * So here need to make sure last core0 is started, esp for two way system,
- * (there may be apic id conflicts in that case)
- */
- start_other_cores();
- wait_all_other_cores_started(bsp_apicid);
+ // It is said that we should start core1 after all core0 launched
+ /* becase optimize_link_coherent_ht is moved out from setup_coherent_ht_domain,
+ * So here need to make sure last core0 is started, esp for two way system,
+ * (there may be apic id conflicts in that case)
+ */
+ start_other_cores();
+ wait_all_other_cores_started(bsp_apicid);
#endif
- /* it will set up chains and store link pair for optimization later */
- ht_setup_chains_x(sysinfo); // it will init sblnk and sbbusn, nodes, sbdn
+ /* it will set up chains and store link pair for optimization later */
+ ht_setup_chains_x(sysinfo); // it will init sblnk and sbbusn, nodes, sbdn
#if CONFIG_SET_FIDVID
- {
- msr_t msr;
- msr = rdmsr(0xc0010042);
- printk(BIOS_DEBUG, "begin msr fid, vid %08x, %08x\n", msr.hi, msr.lo);
- }
- enable_fid_change();
- enable_fid_change_on_sb(sysinfo->sbbusn, sysinfo->sbdn);
- init_fidvid_bsp(bsp_apicid);
- // show final fid and vid
- {
- msr_t msr;
- msr = rdmsr(0xc0010042);
- printk(BIOS_DEBUG, "end msr fid, vid %08x, %08x\n", msr.hi, msr.lo);
- }
+ {
+ msr_t msr;
+ msr = rdmsr(0xc0010042);
+ printk(BIOS_DEBUG, "begin msr fid, vid %08x, %08x\n", msr.hi, msr.lo);
+ }
+ enable_fid_change();
+ enable_fid_change_on_sb(sysinfo->sbbusn, sysinfo->sbdn);
+ init_fidvid_bsp(bsp_apicid);
+ // show final fid and vid
+ {
+ msr_t msr;
+ msr = rdmsr(0xc0010042);
+ printk(BIOS_DEBUG, "end msr fid, vid %08x, %08x\n", msr.hi, msr.lo);
+ }
#endif
init_timer(); // Need to use TMICT to synchronize FID/VID
- needs_reset |= optimize_link_coherent_ht();
- needs_reset |= optimize_link_incoherent_ht(sysinfo);
- needs_reset |= mcp55_early_setup_x();
+ needs_reset |= optimize_link_coherent_ht();
+ needs_reset |= optimize_link_incoherent_ht(sysinfo);
+ needs_reset |= mcp55_early_setup_x();
- // fidvid change will issue one LDTSTOP and the HT change will be effective too
- if (needs_reset) {
- printk(BIOS_INFO, "ht reset -\n");
- soft_reset();
- }
+ // fidvid change will issue one LDTSTOP and the HT change will be effective too
+ if (needs_reset) {
+ printk(BIOS_INFO, "ht reset -\n");
+ soft_reset();
+ }
- allow_all_aps_stop(bsp_apicid);
+ allow_all_aps_stop(bsp_apicid);
- //It's the time to set ctrl in sysinfo now;
+ //It's the time to set ctrl in sysinfo now;
fill_mem_ctrl(sysinfo->nodes, sysinfo->ctrl, spd_addr);
// enable_smbus(); /* enable in sio_setup */
- /* all ap stopped? */
+ /* all ap stopped? */
- sdram_initialize(sysinfo->nodes, sysinfo->ctrl, sysinfo);
+ sdram_initialize(sysinfo->nodes, sysinfo->ctrl, sysinfo);
- post_cache_as_ram(); // bsp swtich stack to RAM and copy sysinfo RAM now
+ post_cache_as_ram(); // bsp swtich stack to RAM and copy sysinfo RAM now
}