# SPDX-License-Identifier: GPL-2.0-only

chip soc/amd/stoneyridge
	register "stapm_percent" = "80"
	register "stapm_time_ms" = "2500000"
	register "stapm_power_mw" = "7800"

	# Enable I2C0 for audio, USB3 hub at 400kHz
	register "i2c[0]" = "{
		.speed = I2C_SPEED_FAST,
		.rise_time_ns = 95,
		.fall_time_ns = 3,
	}"

	# Enable I2C1 for H1 at 400kHz
	register "i2c[1]" = "{
		.early_init = 1,
		.speed = I2C_SPEED_FAST,
		.rise_time_ns = 45,
		.fall_time_ns = 4,
	}"

	# Enable I2C2 for trackpad, pen at 400kHz
	register "i2c[2]" = "{
		.speed = I2C_SPEED_FAST,
		.rise_time_ns = 26,
		.fall_time_ns = 11,
	}"

	# Enable I2C3 for touchscreen at 400kHz
	register "i2c[3]" = "{
		.speed = I2C_SPEED_FAST,
		.rise_time_ns = 20,
		.fall_time_ns = 19,
	}"

	device ref i2c_2 on
		chip drivers/i2c/hid
			register "generic.hid" = ""PNP0C50""
			register "generic.desc" = ""Synaptics Touchpad""
			register "generic.irq_gpio" = "ACPI_GPIO_IRQ_LEVEL_LOW(GPIO_5)"
			register "generic.wake" = "7"
			register "generic.detect" = "1"
			register "hid_desc_reg_offset" = "0x20"
			device i2c 2c on end
		end
	end
	device ref i2c_3 on
		chip drivers/i2c/generic
			register "hid" = ""RAYD0001""
			register "desc" = ""Raydium Touchscreen""
			register "probed" = "1"
			register "irq_gpio" = "ACPI_GPIO_IRQ_EDGE_LOW(GPIO_11)"
			register "reset_gpio" = "ACPI_GPIO_OUTPUT_ACTIVE_HIGH(GPIO_85)"
			register "reset_delay_ms" = "20"
			register "enable_gpio" = "ACPI_GPIO_OUTPUT_ACTIVE_HIGH(GPIO_76)"
			register "enable_delay_ms" = "1"
			register "has_power_resource" = "1"
			register "disable_gpio_export_in_crs" = "1"
			device i2c 39 on end
		end
	end
end	#chip soc/amd/stoneyridge