diff --git a/src/mainboard/google/brya/Kconfig b/src/mainboard/google/brya/Kconfig
index e891924..f72e90b 100644
--- a/src/mainboard/google/brya/Kconfig
+++ b/src/mainboard/google/brya/Kconfig
@@ -421,6 +421,8 @@
 	select BOARD_GOOGLE_BASEBOARD_NISSA
 	select DRIVERS_GENERIC_GPIO_KEYS
 	select CHROMEOS_WIFI_SAR if CHROMEOS
+	select DRIVERS_I2C_SX9324
+	select DRIVERS_I2C_SX9324_SUPPORT_LEGACY_LINUX_DRIVER
 
 config BOARD_GOOGLE_QUANDISO
 	select BOARD_GOOGLE_BASEBOARD_NISSA
diff --git a/src/mainboard/google/brya/variants/pujjoga/overridetree.cb b/src/mainboard/google/brya/variants/pujjoga/overridetree.cb
index a8b9a7e..951d60e 100644
--- a/src/mainboard/google/brya/variants/pujjoga/overridetree.cb
+++ b/src/mainboard/google/brya/variants/pujjoga/overridetree.cb
@@ -186,6 +186,75 @@
 				device generic 0 on end
 			end
 		end
+		device ref i2c2 on
+			chip drivers/i2c/sx9324
+				register "desc" = ""SAR Proximity Sensor""
+				register "irq" = "ACPI_IRQ_LEVEL_LOW(GPP_H19_IRQ)"
+				register "speed" = "I2C_SPEED_FAST"
+				register "uid" = "1"
+				register "reg_gnrl_ctrl0" = "0x16"
+				register "reg_gnrl_ctrl1" = "0x21"
+				register "reg_afe_ctrl0" = "0x00"
+				register "reg_afe_ctrl1" = "0x10"
+				register "reg_afe_ctrl2" = "0x00"
+				register "reg_afe_ctrl3" = "0x00"
+				register "reg_afe_ctrl4" = "0x47"
+				register "reg_afe_ctrl5" = "0x00"
+				register "reg_afe_ctrl6" = "0x00"
+				register "reg_afe_ctrl7" = "0x47"
+				register "reg_afe_ctrl8" = "0x12"
+				register "reg_afe_ctrl9" = "0x08"
+				register "reg_afe_ph0" = "0x3d"
+				register "reg_afe_ph1" = "0x1b"
+				register "reg_afe_ph2" = "0x1f"
+				register "reg_afe_ph3" = "0x3d"
+				register "reg_prox_ctrl0" = "0x0b"
+				register "reg_prox_ctrl1" = "0x0a"
+				register "reg_prox_ctrl2" = "0x90"
+				register "reg_prox_ctrl3" = "0x60"
+				register "reg_prox_ctrl4" = "0x0c"
+				register "reg_prox_ctrl5" = "0x00"
+				register "reg_prox_ctrl6" = "0x19"
+				register "reg_prox_ctrl7" = "0x58"
+				register "reg_adv_ctrl0" = "0x00"
+				register "reg_adv_ctrl1" = "0x00"
+				register "reg_adv_ctrl2" = "0x00"
+				register "reg_adv_ctrl3" = "0x00"
+				register "reg_adv_ctrl4" = "0x00"
+				register "reg_adv_ctrl5" = "0x05"
+				register "reg_adv_ctrl6" = "0x00"
+				register "reg_adv_ctrl7" = "0x00"
+				register "reg_adv_ctrl8" = "0x00"
+				register "reg_adv_ctrl9" = "0x00"
+				register "reg_adv_ctrl10" = "0x00"
+				register "reg_adv_ctrl11" = "0x00"
+				register "reg_adv_ctrl12" = "0x00"
+				register "reg_adv_ctrl13" = "0x00"
+				register "reg_adv_ctrl14" = "0x80"
+				register "reg_adv_ctrl15" = "0x0c"
+				register "reg_adv_ctrl16" = "0x08"
+				register "reg_adv_ctrl17" = "0x56"
+				register "reg_adv_ctrl18" = "0x33"
+				register "reg_adv_ctrl19" = "0x00"
+				register "reg_adv_ctrl20" = "0x00"
+
+				register "ph0_pin" = "{1, 3, 3}"
+				register "ph1_pin" = "{3, 2, 1}"
+				register "ph2_pin" = "{3, 3, 1}"
+				register "ph3_pin" = "{1, 3, 3}"
+				register "ph01_resolution" = "1024"
+				register "ph23_resolution" = "1024"
+				register "startup_sensor" = "1"
+				register "ph01_proxraw_strength" = "3"
+				register "ph23_proxraw_strength" = "2"
+				register "avg_pos_strength" = "256"
+				register "cs_idle_sleep" = ""hi-z""
+				register "int_comp_resistor" = ""lowest""
+				register "input_precharge_resistor_ohms" = "4000"
+				register "input_analog_gain" = "1"
+				device i2c 28 on end
+			end
+		end
 		device ref i2c3 on
 			chip drivers/i2c/generic
 				register "hid" = ""RTL5682""