mainboard: Drop print_ implementation from non-romcc boards
Because we had no stack on romcc boards, we had a separate, not as
powerful clone of printk: print_*. Back in the day, like more than
half a decade ago, we migrated a lot of boards to printk, but we never
cleaned up the existing code to be consistent. instead, we worked around
the problem with a very messy console.h (nowadays the mess is hidden in
romstage_console.c and early_print.h)
This patch cleans up the mainboard code to use printk() on all non-ROMCC
boards.
Change-Id: I2383f24343fc2041fef4af65d717d754ad58425e
Signed-off-by: Stefan Reinauer <stefan.reinauer@coreboot.org>
Reviewed-on: http://review.coreboot.org/8111
Reviewed-by: Edward O'Callaghan <eocallaghan@alterapraxis.com>
Tested-by: build bot (Jenkins)
diff --git a/src/mainboard/gigabyte/m57sli/romstage.c b/src/mainboard/gigabyte/m57sli/romstage.c
index da12a97..ebfe2a8 100644
--- a/src/mainboard/gigabyte/m57sli/romstage.c
+++ b/src/mainboard/gigabyte/m57sli/romstage.c
@@ -144,9 +144,8 @@
/* Halt if there was a built in self test failure */
report_bist_failure(bist);
- printk(BIOS_DEBUG, "*sysinfo range: [%p,%p]\n",sysinfo,sysinfo+1);
-
- print_debug("bsp_apicid="); print_debug_hex8(bsp_apicid); print_debug("\n");
+ printk(BIOS_DEBUG, "*sysinfo range: [%p,%p]\n", sysinfo, sysinfo+1);
+ printk(BIOS_DEBUG, "bsp_apicid=%02x\n", bsp_apicid);
set_sysinfo_in_ram(0); // in BSP so could hold all ap until sysinfo is in ram
setup_coherent_ht_domain(); // routing table and start other core0
@@ -169,7 +168,7 @@
{
msr_t msr;
msr=rdmsr(0xc0010042);
- print_debug("begin msr fid, vid "); print_debug_hex32( msr.hi ); print_debug_hex32(msr.lo); print_debug("\n");
+ printk(BIOS_DEBUG, "begin msr fid, vid %08x%08x\n", msr.hi, msr.lo);
}
enable_fid_change();
enable_fid_change_on_sb(sysinfo->sbbusn, sysinfo->sbdn);
@@ -178,7 +177,7 @@
{
msr_t msr;
msr=rdmsr(0xc0010042);
- print_debug("end msr fid, vid "); print_debug_hex32( msr.hi ); print_debug_hex32(msr.lo); print_debug("\n");
+ printk(BIOS_DEBUG, "end msr fid, vid %08x%08x\n", msr.hi, msr.lo);
}
#endif
@@ -190,7 +189,7 @@
// fidvid change will issue one LDTSTOP and the HT change will be effective too
if (needs_reset) {
- print_info("ht reset -\n");
+ printk(BIOS_INFO, "ht reset -\n");
soft_reset();
}
allow_all_aps_stop(bsp_apicid);